本文關鍵詞： 鋼結構 涂層 風沙 沖蝕程度評價 相似性理論　出處：《建筑材料學報》2015年05期 　論文類型：期刊論文

【摘要】：針對內蒙古中西部地區鋼結構體系表面涂層長期遭受風沙沖蝕這一現狀,采用氣流挾沙噴射法,對鋼結構涂層受風沙沖蝕磨損的程度進行了研究及分析;提出了評價涂層沖蝕磨損程度的計算方法,并應用相似性理論將試驗結果與實際工況進行了對比分析.結果表明:涂層的沖蝕磨損質量損失隨沖蝕速度的增加而增加;最大沖蝕磨損質量損失出現在沖蝕角度為45°時,最小沖蝕磨損質量損失出現在沖蝕角度為90°時;所提出的涂層沖蝕磨損程度評價公式計算結果與試驗結果基本吻合;試驗條件為下沙率360g/min,沖蝕速度30m/s,沖蝕時間12min的涂層沖蝕磨損結果,相當于強沙塵暴密集區的鋼結構涂層受到5.05~83.0個月的沖蝕磨損.
[Abstract]:In view of the fact that the surface coating of steel structure system has been eroded by wind and sand for a long time in the central and western region of Inner Mongolia, the degree of erosion and wear of the coating of steel structure by wind and sand erosion is studied and analyzed by means of airflow sand jet method. A calculation method to evaluate the erosion wear degree of coating is put forward, and the test results are compared with the actual working conditions by using similarity theory. The results show that the erosion wear mass loss of the coating increases with the increase of erosion velocity. The maximum erosion wear mass loss occurs when the erosion angle is 45 擄and the minimum erosion wear mass loss occurs when the erosion angle is 90 擄. The experimental conditions are as follows: the erosion rate is 360 g / min, the erosion rate is 30 m / s, and the erosion time is 12 min, which is equivalent to the erosion wear of steel structure coating in the area of strong dust storm concentration for 5.05 ~ 83.0 months.
【作者單位】： 內蒙古工業大學土木工程學院;中國電力科學研究院;
【基金】：國家自然科學基金資助項目(11162011,51468049) 內蒙古自治區自然科學基金資助項目(2009 MS0706) 國家電網公司科技項目(輸電線路環境因素若干問題研究)
【分類號】：TG174.4

【參考文獻】

相關期刊論文 前5條

1 劉景濤,鄭明倩;內蒙古中西部強和特強沙塵暴的氣候?qū)W特征[J];高原氣象;2003年01期

2 郝，

本文編號：1496832