【摘要】：為了合理有效地選擇橡膠瀝青結合料制備過程中的膠粉摻量、外摻劑摻量及制備工藝參數,對其進行了多項性能的"4因素3水平"正交試驗,分析了剪切時間、剪切溫度、膠粉摻量及硫摻量對各項性能變化趨勢及影響程度,并確定了各項制備工藝參數及外摻劑的優化組合方案。研究結果表明:膠粉摻量對橡膠瀝青結合料各項性能均有顯著影響,增加膠粉摻量能有效提高其高溫性能,但同時降低其低溫性能與彈性恢復能力,其最佳摻量應為20%~25%;剪切時間應在30min以上以保證膠粉充分溶脹,但剪切時間過長會導致橡膠瀝青各項性能的顯著降低,剪切時間應在30~60min之間;增大硫摻量能抑制橡膠瀝青中的脫硫反應,在一定程度提高橡膠瀝青高溫性能,但過大的硫摻量會造成低溫性能的顯著下降,橡膠瀝青中硫摻量宜小于膠粉摻量的0.6%;橡膠瀝青室內制備參數及外摻劑含量存在優化組合方案。
[Abstract]:In order to reasonably and effectively select the amount of rubber powder, the amount of admixture and the technological parameters of preparation of rubber asphalt binder, the orthogonal experiments of "4 factors and 3 levels" for many properties were carried out, and the shear time and temperature were analyzed. The change trend and influence degree of rubber powder and sulfur content on the properties were determined. The preparation process parameters and the optimized combination scheme of the admixture were determined. The results show that the content of rubber powder has a significant effect on the properties of rubber asphalt binder. Increasing the content of rubber powder can effectively improve its high temperature performance, but at the same time reduce its low temperature performance and elastic recovery ability. The optimum dosage should be 20 / 25, the shearing time should be above 30min to ensure that the rubber powder is fully swelled, but if the shearing time is too long, the properties of rubber asphalt will be significantly reduced, and the shearing time should be between 30~60min; Increasing sulfur content can inhibit the desulfurization reaction in rubber asphalt and improve the high temperature performance of rubber asphalt to a certain extent. The content of sulfur in rubber asphalt should be smaller than that of rubber powder, and the preparation parameters and admixture content of rubber asphalt should be optimized.
【作者單位】： 長安大學公路學院;廣西交通科學研究院
【基金】：國家自然科學基金項目(51078040) 交通運輸部西部交通建設科技項目(2011 318 788 1280) 中央高校基本科研業務費專項資金項目(CHD20115Y003)
【分類號】：U414

【參考文獻】

相關期刊論文 前3條

1 黃文元;張隱西;;路面工程用橡膠瀝青的反應機理與進程控制[J];公路交通科技;2006年11期

2 郭朝陽;何兆益;曹陽;;廢胎膠粉改性瀝青改性機理研究[J];中外公路;2008年02期

3 肖川;凌天清;;廢舊橡膠粉改性瀝青材料在道路工程中的應用與研究[J];公路工程;2009年04期

【共引文獻】

相關期刊論文 前10條

1 宋財福;張鵬;譚建志;;PE管件注塑成型工藝優化設計[J];工程塑料應用;2011年05期

2 闞清華;湯斌;張慶慶;張海龍;;滬釀3.042米曲霉產中性蛋白酶條件的優化[J];安徽工程科技學院學報(自然科學版);2010年02期

3 張U，

本文編號：2225969