【摘要】：分別在1 573,1 323K對UNS S31803雙相不銹鋼進行了固溶處理,再依次進行了冷軋和退火處理,利用電子背散射衍射和雙環電化學動電位再活化法研究了該鋼內界面特征分布和晶間腐蝕敏感性,并分析了二者之間的關系。結果表明:在1 573K固溶并經冷軋退火后,試驗鋼得到了α+!兩相均勻分布的等軸組織,出現了大量滿足K-S和N-W取向關系的低能相界,且α相中低界面能的小角度晶界所占比例超過50%,這些低能界面抑制了晶粒的長大,提高了試驗鋼的耐晶間腐蝕性能;在1 323K固溶并經冷軋退火后,試驗鋼的顯微組織為α+γ兩相條帶組織,滿足K-S和N-W關系的相界較少,α相中以大角度晶界為主,其耐晶間腐蝕性能較差。
[Abstract]:UNS S31803 duplex stainless steel was treated by solid solution treatment at 1573 K and 1323K, then cold rolled and annealed in turn. The interfacial characteristic distribution and intergranular corrosion sensitivity of the steel were studied by electron backscattering diffraction and double ring electrochemical potentiodynamic reactivation method, and the relationship between them was analyzed. The results show that 偽 is obtained after solid solution at 1573 K and cold rolling annealing. There are a large number of low energy phase boundaries satisfying the orientation relationship between K 鈮，

本文編號：2498277