退火處理對變形鎂鋰合金顯微組織及性能的影響
發布時間：2019-01-12 16:38
【摘要】：對Mg-4Li和Mg-6Li合金進行熱擠壓處理后,在不同溫度下進行退火,研究退火工藝對合金顯微組織與性能的影響。結果表明:經290℃熱擠壓后,Mg-4Li合金中α相產生了局部再結晶,而Mg-6Li合金中的β相優先于α相基本完成再結晶。與Mg-4Li合金相比,由于β相的存在,Mg-6Li合金完全再結晶的退火溫度可降低至200℃,并且擠壓及退火態Mg-6Li合金的硬度也降低。
[Abstract]:Mg-4Li and Mg-6Li alloys were hot-extruded and annealed at different temperatures. The effect of annealing process on microstructure and properties of the alloys was studied. The results show that local recrystallization occurs in 偽 phase of Mg-4Li alloy after hot extrusion at 290 鈩，
本文編號：2407987
[Abstract]:Mg-4Li and Mg-6Li alloys were hot-extruded and annealed at different temperatures. The effect of annealing process on microstructure and properties of the alloys was studied. The results show that local recrystallization occurs in 偽 phase of Mg-4Li alloy after hot extrusion at 290 鈩，
本文編號：2407987
本文鏈接：http://sikaile.net/kejilunwen/jiagonggongyi/2407987.html
最近更新
教材專著
