發布時間：2018-11-20 05:45

【摘要】：以1235鑄軋板(7.0 mm)經過兩道次冷軋后的1.1 mm厚的冷軋坯料為對象,借助光學顯微鏡(OM)、掃描電子顯微鏡(SEM)及能譜分析儀(EDS)、定量金相分析技術和電解拋光等試驗手段,研究了退火溫度對1.1 mm厚的1235鋁箔坯料組織的影響。結果表明:在相同的退火時間(6 h)內,隨退火溫度(320~420℃)升高,析出相(Al Fe Si)數量先增加而后減少且粗化;退火溫度為380℃時,析出相數量多且均勻細小,平均尺寸約為3μm。再結晶溫度的區間為320~340℃;隨著退火溫度升高,再結晶晶粒逐漸長大;退火溫度為380℃時,再結晶晶粒數量多且均勻細小,平均尺寸約為23μm。因此,在380℃保溫6 h的退火工藝最佳。
[Abstract]:The 1. 1 mm thick cold rolled blank of 1235 cast and rolled sheet (7. 0 mm) after two cold rolling passes was taken as an object. (OM), scanning electron microscope (SEM) and energy dispersive analyzer (EDS),) were used for scanning electron microscope (SEM) and energy spectrum analyzer (EDS),). The effect of annealing temperature on the microstructure of 1235 aluminum foil blank with 1. 1 mm thickness was studied by quantitative metallographic analysis and electrolytic polishing. The results show that in the same annealing time (6 h), with the increase of annealing temperature (320,420 鈩，

本文編號：2343950