【摘要】：以摩擦因數和摩擦失重量為指標,并參照磨損形貌,研究了載荷對表面鍍有Ni-W-SiC鍍層的汽車發動機活塞環的摩擦性能的影響。結果表明:隨著載荷的增大,摩擦因數降低,而摩擦失重量升高。當載荷為5N時,穩定時摩擦因數約為0.43,摩擦失重量約為1.83 mg;當載荷增至10N和20N時,穩定時摩擦因數分別為0.37和0.32,摩擦失重量分別為2.14mg和2.37mg。載荷變化未影響活塞環表面Ni-W-SiC鍍層的摩擦機制。
[Abstract]:The effect of load on the friction performance of the piston ring of automobile engine coated with Ni-W-SiC coating was studied by taking friction coefficient and weight loss as the index and referring to the wear morphology. The results show that the friction coefficient decreases and the friction weight increases with the increase of load. When the load is 5 N, the friction coefficient is about 0.43 and the friction loss weight is about 1.83 mg;. When the load is increased to 10 N and 20 N, the friction coefficient is 0.37 and 0.32, and the friction loss weight is 2.14mg and 2.37 mg respectively. The friction mechanism of Ni-W-SiC coating on piston ring surface was not affected by load change.
【作者單位】： 蘇州工業職業技術學院;
【基金】：江蘇高校品牌專業建設工程資助項目(PPZY2015B186)
【分類號】：TG174.4

【相似文獻】

相關期刊論文 前4條

1 郭忠誠,楊顯萬,劉鴻康,王志英,王敏;SiC微粒對Ni-W-SiC復合鍍層工藝及性能的影響[J];化工冶金;1997年02期

2 張際先,桑正中,高良潤;土壤對固體材料粘附和摩擦性能的研究[J];農業機械學報;1986年01期

3 朱雙霞;周小平;李玉平;黃國兵;;磨削加工表面的摩擦性能分析[J];制造技術與機床;2008年07期

4 ;石棉樹脂材料Z64的摩擦性能試驗[J];鍛壓機械;1975年04期

，

本文編號：2336767