發布時間：2018-11-14 09:51

【摘要】：針對交叉筋壁板激光成形后的整體扭曲變形現象,采用相應的校正方法對板材進行了校正,并利用有限元分析進行了研究。研究表明交叉筋壁板激光成形后出現的整體扭曲現象是由板材中部加強筋側傾失穩造成的,提出板材掃描線不同部位協同變形為成形的關鍵并提出了協同變形掃描方式。針對協同變形掃描方式消除板材整體扭曲變形的現象進行了有限元分析,結果顯示采用協同變形掃描方式后板材中部蒙皮所受到的約束減小,產生的拉應力減小,從而減小了對中部加強筋的壓縮,消除了中部筋的側傾失穩,最終避免了交叉筋壁板激光成形后的整體扭曲現象。
[Abstract]:In view of the distortion phenomenon of the cross stiffened panel after laser forming, the corresponding correction method is used to correct the plate, and the finite element analysis is used to study it. The research shows that the overall distortion of the cross bar wall plate after laser forming is caused by the roll instability of the reinforcing bar in the middle of the plate. The cooperative deformation of different parts of the plate scanning line is proposed as the key to the forming and the cooperative deformation scanning mode is also put forward. The finite element analysis is carried out to eliminate the distortion of the whole plate by the cooperative deformation scanning method. The results show that the constraint of the skin in the middle part of the plate is reduced and the tensile stress is reduced after the cooperative deformation scanning method is adopted. Thus, the compression of the central stiffener is reduced, the roll instability of the central reinforcement is eliminated, and the overall distortion of the cross-stiffened wall plate is avoided after laser forming.
【作者單位】： 哈爾濱工業大學機電工程學院航空宇航制造工程系;
【基金】：國家科技重大專項(2014ZX04001-151) 國家自然科學基金(51375120)資助
【分類號】：TG665

【相似文獻】

相關會議論文 前1條

1 陳利紅;;論語言的扭曲現象[A];貴州省翻譯工作者協會2008年翻譯學術研討會交流論文匯編[C];2008年

，

本文編號：2330826