天堂国产午夜亚洲专区-少妇人妻综合久久蜜臀-国产成人户外露出视频在线-国产91传媒一区二区三区

當前位置:主頁 > 科技論文 > 鑄造論文 >

耐熱合金鋼P(yáng)91熱變形過程靜態及亞動態再結晶行為

發布時間:2018-11-10 09:00
【摘要】:利用單道次、雙道次熱壓縮試驗研究鑄態P91合金鋼在熱變形后的動態、靜態、亞動態再結晶行為,探索不同變形溫度、應變速率、變形量對靜態、亞動態再結晶的影響并建立靜態、亞動態再結晶動力學方程。研究得出:熱變形結束后,靜態再結晶率隨變形溫度、變形量及應變速率的增大而增大;亞動態再結晶率與變形溫度、變形量和應變速率呈單調遞增,并最終趨于穩定。以真應變?yōu)閰?shù),鑄態P91熱變形后再結晶類型可按照真應變分為三種情況:當εε_(tái)c時,道次間隔主要發生靜態再結晶;當ε_(tái)cεε_(tái)T時,同時發生靜態、亞動態再結晶;當εε_(tái)T時,主要發生亞動態再結晶。通過對雙道次壓縮試樣的顯微組織分析得出:相同變形條件下,亞動態再結晶晶粒比靜態再結晶細小,再結晶晶粒隨變形溫度增加而增大,隨應變速率增大而減小。
[Abstract]:The dynamic, static and subdynamic recrystallization behavior of as-cast P91 alloy steel after hot deformation was studied by single pass and double pass thermal compression test. The effect of subdynamic recrystallization and the kinetic equations of static and subdynamic recrystallization were established. The results show that the static recrystallization rate increases with the increase of deformation temperature, deformation rate and strain rate, and the subdynamic recrystallization rate increases monotonously with deformation temperature, deformation rate and strain rate, and eventually tends to be stable. The recrystallization types of as-cast P91 can be divided into three cases according to the true strain: static recrystallization at 蔚 c, static recrystallization at 蔚 c 蔚 T and subdynamic recrystallization at the same time when 蔚 c 蔚 T. When 蔚 _ T, subdynamic recrystallization occurs. The microstructure analysis of double pass compression specimens shows that the subdynamic recrystallization grains are finer than those of static recrystallization under the same deformation conditions. The recrystallization grains increase with the increase of deformation temperature and decrease with the increase of strain rate.
【作者單位】: 太原科技大學材料科學與工程學院;太原科技大學金屬材料成性理論與技術山西省重點實驗室;
【基金】:山西省回國留學人員科研(2015-086) 國家自然科學基金(51135007,51675361)資助項目
【分類號】:TG142.1

【相似文獻】

相關期刊論文 前10條

1 臧爾壽;張厚君;;鈮對共析軌鋼動態再結晶的影響[J];物理測試;1990年01期

2 張鴻冰,張斌,柳建韜;鋼中動態再結晶力學測定及其數學模型[J];上海交通大學學報;2003年07期

3 李龍飛,楊王s,

本文編號:2321984


資料下載
論文發表

本文鏈接:http://sikaile.net/kejilunwen/jiagonggongyi/2321984.html


Copyright(c)文論論文網All Rights Reserved | 網站地圖 |

版權申明:資料由用戶e7fb5***提供,本站僅收錄摘要或目錄,作者需要?jiǎng)h除請E-mail郵箱bigeng88@qq.com