【摘要】：采用電化學技術等試驗方法,研究了鍍液p H值及溫度對AZ31鎂合金化學鍍Ni-P合金鍍層的鍍速、孔隙率、點滴腐蝕試驗時間、腐蝕電位、腐蝕電流和交流阻抗的影響。結果表明,當鍍液pH值為7時,AZ31鎂合金化學鍍Ni-P合金鍍層的沉積速率最大,為8.48μm/h,顯微硬度高(250 kgf/mm~2),孔隙率為0個/cm~2,Na Cl點滴腐蝕試驗時間最長,為90 s,腐蝕電流密度小,為0.177 m A/cm~2,腐蝕電位最大,為-1.015 V。當鍍液溫度為75℃時,鍍層的沉積速率大,耐蝕性能好。鍍層包狀物顆粒均勻、緊密、無缺陷。
[Abstract]:The effects of bath pH value and temperature on the plating rate, porosity, droplet corrosion test time, corrosion potential, corrosion current and AC impedance of AZ31 magnesium alloy electroless plating Ni-P alloy coating were studied by electrochemical technique. The results show that when the pH value of the plating solution is 7, the deposition rate of the electroless Ni-P alloy coating on AZ31 magnesium alloy is 8.48 渭 m / h, the microhardness is high (250 kgf/mm~2), the porosity is 0 / cm~2,Na Cl drop corrosion test time is the longest. The corrosion current density is 0.177 Ma / cm ~ (-2) and the corrosion potential is-1.015 V. When the bath temperature is 75 鈩，

本文編號：2320879