【摘要】：研究了TC4鈦合金蜂窩板的釬焊工藝,試驗采用Ti-Zr-Ni-Cu釬料,真空度不低于2×10~(-3)Pa,釬焊溫度為930℃,保溫時間為30 min.對焊后試件的釬焊界面組織進行超聲無損檢測,檢測結果表明面板與蜂窩芯釬焊效果極好,未發現有脫焊、虛焊等現象.采用掃描電鏡(SEM)和能譜分析(EDS)法進行了試驗分析.結果表明,母材和釬料發生相互擴散滲透反應,并出現有新的析出相.該工藝下蜂窩板的界面平均拉脫強度為12.8 MPa,抗剪強度為9.01 MPa,釬焊接頭屬于脆性斷裂.
[Abstract]:The brazing process of TC4 titanium alloy honeycomb plate was studied. The Ti-Zr-Ni-Cu solder was used in the test. The vacuum degree was not less than 2 脳 10 ~ (-3) Pa, brazing temperature was 930 鈩，

本文編號：2312885