【摘要】：采用壓延輔助雙軸織構基板制備路線成功軋制出長度大于100 m、厚度約為66μm的Ni-5at%W(Ni5W)合金長帶,從中截取10 m長帶在自制的卷到卷熱處理系統中進行再結晶動態退火處理。XRD織構分析顯示,整條長帶退火前的軋制織構含量平均值為63.8%(≤10°),動態退火長帶面內和面外織構的半高寬平均值分別為7.2°和6.1°。EBSD分析發現,基帶立方織構含量為98.7%(≤10°),小角晶界含量為87.7%(≤10°)。長帶軋制過程中變更軋機時增加首道次壓下量可以有效改善軋制過程中帶材斷裂的情況。此工藝可以制備出符合YBCO超導層需求的、具有高立方織構含量和均勻性的Ni5W合金長帶。
[Abstract]:Ni-5at%W (Ni5W) alloy strip with length of more than 100m and thickness of about 66 渭 m was successfully rolled by calendering assisted biaxial texture substrate. The recrystallization dynamic annealing treatment. XRD texture analysis showed that the 10m long band was cut off in a self-made coil to coil heat treatment system. The average rolling texture content of the whole strip before annealing is 63.8% (鈮，

本文編號：2173955