【摘要】：利用放電等離子燒結技術制備生物醫用Ti-24Nb-4Zr-8Sn合金,研究固溶時效處理對合金顯微組織和力學性能(強度、塑韌性及彈性模量)的影響。結果表明:合金經850℃固溶處理后主要由β相、少量初生α相及淬火馬氏體α″相組成;在450℃時效處理后,合金基體β相內析出大量細小無規則的針狀次生α相,隨著時效時間從4 h延長到48 h,次生α相趨于定向析出,含量和尺寸逐漸增大;與燒結態相比,固溶時效處理后合金抗壓強度和彈性模量增大,而塑韌性呈先提高后降低趨勢;經優化后固溶時效處理制度為(850℃,1.5 h,WQ)+(450℃,4 h,FC),此時合金抗壓強度、屈強比和彈性模量分別為1701 MPa、0.69 GPa和42.8 GPa。
[Abstract]:Biomedical Ti-24Nb-4Zr-8Sn alloy was prepared by spark plasma sintering (SPS). The effect of solution aging treatment on microstructure and mechanical properties (strength, ductility and elastic modulus) of the alloy was studied. The results show that the alloy is mainly composed of 尾 phase, a small amount of primary 偽 phase and quenched martensite 偽 "phase after solution treatment at 850 鈩，

本文編號：2151429