【摘要】：對金屬間化合物Ti2AlNb基合金在加熱狀態下的變形行為和變形機理進行研究。首先,利用單向拉伸試驗得到不同溫度和應變速率下合金的真應力-應變關系;然后,通過拉深和彎曲試樣得到合金的極限拉深比(LDR)及彎曲性能參數;最后,通過金相實驗和斷口形貌分析研究Ti2AlNb基合金在不同加熱條件下的高溫變形機制。結果表明:在750~950℃、應變速率0.001 s~(-1)的條件下,隨著溫度的升高,合金的伸長率從13.58%增大至97.82%,屈服強度從788 MPa降低至80 MPa;當溫度達到950℃時,應變速率對合金的變形性能有明顯影響。同時,在該溫度范圍內,材料發生由O相向B2和α2相的組織轉變,從微觀組織演變揭示了Ti2AlNb基合金塑性提高的變形機理。
[Abstract]:The deformation behavior and mechanism of Ti _ 2AlNb based alloy under heating condition were studied. First, the true stress-strain relationship of the alloy at different temperatures and strain rates is obtained by uniaxial tensile test. Then, the ultimate drawing ratio (LDR) and bending performance parameters of the alloy are obtained by drawing and bending specimens. The deformation mechanism of Ti _ 2AlNb based alloy at high temperature under different heating conditions was studied by metallographic test and fracture morphology analysis. The results show that the elongation of the alloy increases from 13.58% to 97.82 at 750 鈩，

本文編號：2137880