本文選題：坡口間隙 + 多層多道焊接��； 參考：《焊接學報》2017年09期

【摘要】：坡口間隙的存在及其在不同拘束條件下會對焊接變形產生不同影響.以平板對接多層多道焊為研究對象,將坡口間隙作為考慮因素添加到焊接數值模擬模型中,采用試驗測量與焊接仿真相結合的方法,在不同拘束條件下研究坡口間隙對焊接變形的影響效果,為進一步利用數值方法解決焊接變形問題提供了參考依據.結果表明,相同拘束條件下,有無坡口間隙對焊接變形趨勢影響并不明顯,但對殘余變形數值大小影響顯著,且在彈簧拘束條件下焊接變形結果差別最大;被焊平板存在坡口間隙時,彈簧拘束條件下的模擬結果與自由狀態下焊接試驗獲得的焊接變形結果最為一致.
[Abstract]:The existence of groove clearance and its influence on welding deformation under different restraint conditions. Taking the multi-layer and multi-pass welding of plate butt joint as the research object, the groove clearance is added to the numerical simulation model of welding, and the method of combining experimental measurement with welding simulation is adopted. The effect of groove clearance on welding deformation is studied under different restraint conditions, which provides a reference for solving welding deformation problem by numerical method. The results show that the effect of groove clearance on welding deformation is not obvious under the same restraint condition, but it has a significant effect on the value of residual deformation, and the difference of welding deformation under spring restraint is the greatest. When the groove gap exists in the welded plate, the simulation results under spring restraint condition are most consistent with the welding deformation results obtained by welding test in free state.
【作者單位】： 江蘇徐州工程機械研究院;徐工集團工程機械有限公司高端工程機械智能制造國家重點實驗室;南京航空航天大學材料科學與技術學院;
【分類號】：TG404

【相似文獻】

相關期刊論文 前10條

1 尚軍民;利用焊接變形的實例[J];焊接;2000年03期

2 蔡志鵬,趙海燕,鹿安理;提高彈性能模型方法預測焊接變形實用性的研究[J];機械工程學報;2003年07期

3 侯志剛,馬W，

本文編號：1811950