發布時間：2018-04-27 18:28

  本文選題：高密齒鋁型材 + 擠壓模具��； 參考：《鍛壓技術》2017年12期

【摘要】：高密齒散熱器型材由于其截面形狀復雜、舌比值(懸臂∶齒間距)大而使其擠壓模具設計難度大、試模成功率低。以某公司生產的高密齒散熱器鋁型材為例,采用數值模擬軟件Hyperxtrude對其擠壓成形過程進行分析研究。將原設計模具在仿真軟件上進行虛擬試模,找出可能存在的問題,再結合實際試模情況和模擬結果對模具結構和參數進行多次優化。主要通過改變導流板角度和工作帶尺寸,使得型材截面最大擠出速度與平均速度的比值趨近于1。結果表明:經優化后的模具消除了原來存在的問題,擠出了合格的高密齒型材。
[Abstract]:Because of its complicated section shape and large tongue ratio (cantilever: tooth spacing), the extrusion die design of high density radiator profile is difficult and the success rate of die test is low. Taking the aluminum profile of high density radiator produced by a company as an example, the extrusion forming process was analyzed and studied by numerical simulation software Hyperxtrude. The original design mould is simulated on the simulation software to find out the possible problems and then to optimize the mold structure and parameters several times by combining the actual mold test and simulation results. By changing the angle of the guide plate and the size of the working belt, the ratio of the maximum extrusion speed to the average velocity of the profile section approaches to 1. The results showed that the optimized die eliminated the original problems and extruded qualified high density profile.
【作者單位】： 燕山大學機械工程學院;
【分類號】：TG376

【相似文獻】

相關碩士學位論文 前1條

1 馬鋒;基于ABAQUS平臺對鋁合金焊接變形和應力的數值模擬及研究[D];重慶交通大學;2016年

，

本文編號：1811819