本文選題：Al-Zn-Mg-Cu-Zr合金(AA) + 平面應變壓縮��； 參考：《稀有金屬材料與工程》2017年11期

【摘要】：采用Gleeble-1500D熱模擬試驗機根據設計的軋制工藝對7055合金進行多道次熱壓縮試驗,模擬其企業熱軋過程,采用電子背散射衍射和透射電鏡研究了再結晶特征。在不同變形條件下,表現出不同的再結晶機制,主要動態再結晶機制有連續動態再結晶和幾何動態再結晶。前者的形核機制主要為原始晶界弓出形核和亞晶合并形核;后者歸因于嚴重的不均勻變形。在道次間的間隙期間,靜態再結晶發生。另外,尺寸大于1μm的第二相也促進再結晶。
[Abstract]:The multi-pass hot compression test of 7055 alloy was carried out by Gleeble-1500D thermal simulation machine according to the designed rolling technology. The hot rolling process of 7055 alloy was simulated. The recrystallization characteristics were studied by electron backscattering diffraction and transmission electron microscope.Under different deformation conditions, different recrystallization mechanisms were observed. The main dynamic recrystallization mechanisms were continuous dynamic recrystallization and geometric dynamic recrystallization.The nucleation mechanism of the former is mainly the primary grain boundary arcuate nucleation and the subcrystalline amalgamation nucleation, while the latter is attributed to serious inhomogeneous deformation.Static recrystallization occurs during the interpass gap.In addition, the second phase larger than 1 渭 m also promotes recrystallization.
【作者單位】： 內蒙古工業大學;北京有色金屬研究總院;江西理工大學工程研究院;
【基金】：National Natural Science Foundation of China(51461017) Natural Science Foundation of Inner Mongolia(2011bs0802)
【分類號】：TG146.21;TG339
，

本文編號：1756459