本文選題：不銹鋼 + 激光焊接�。� 參考：《熱加工工藝》2016年21期

【摘要】：采用YAG脈沖激光焊對304不銹鋼薄板進行了搭接焊接,焊后并進行了不同工藝的熱處理,分析了熱處理工藝對焊接接頭組織、硬度和抗拉強度的影響。試驗結果表明:對焊接試樣進行1000℃保溫60min水冷(固溶處理)后,焊縫中心顯微組織呈等軸晶,組織細小分布均勻,焊縫邊緣呈柱狀晶,垂直熔合線向中心延伸。焊縫區平均硬度達到216.4HV,接頭抗拉強度為375MPa,遠高于其他熱處理工藝的接頭抗拉強度。采用該熱處理工藝,焊縫質量較好,具有較高的力學性能。
[Abstract]:YAG pulse laser welding was used to weld 304 stainless steel sheet. After welding, the effect of heat treatment on the microstructure, hardness and tensile strength of the welded joint was analyzed.The results show that the microstructure of the weld is equiaxed, the microstructure is uniform, the edge of the weld is columnar, and the vertical fusion line extends to the center after 1000 鈩，

本文編號：1752627