本文選題：ADC合金 + 壓鑄鋁合金��； 參考：《熱加工工藝》2017年06期

【摘要】：以ADC12壓鑄鋁合金化學成分為基礎,在合金中加入了額外的2%與4%Cu,并進行了不同的熱處理工藝研究,探討了鋁合金在無鼓泡缺陷時最佳的固溶處理溫度、時間以及組織性能特點。結果表明:避免ADC12鋁合金壓鑄件在熱處理過程中表面鼓泡缺陷的最高溫度和時間為490℃/0.25 h,若在更高的溫度或更長時間進行熱處理,則鑄件會產生鼓泡缺陷。添加Cu的ADC12鋁合金,在460~490℃固溶處理時,硬度隨著Cu含量的增加而增大,而強度卻隨著Cu含量的增加而降低。當鋁合金的高溫強度大于12.54 MPa時,不會發生表面鼓泡缺陷。
[Abstract]:Based on the chemical composition of ADC12 die-casting aluminum alloy, additional 2% and 4Cu2% were added to the alloy, and different heat treatment processes were carried out. The optimum solution treatment temperature, time, microstructure and properties of aluminum alloy without bubbling defects were discussed.The results show that the highest temperature and time of surface blistering defects of ADC12 aluminum alloy die castings during heat treatment are 490 鈩，

本文編號：1733974