本文關鍵詞：電磁鑄造對Al-Zn-Mg-Cu-Zr合金微觀組織及晶內固溶度的影響，由筆耕文化傳播整理發布。

您的位置：首頁 -> 詞典 -> Cu-Cr-Zr-Mg合金

1)  Cu-Cr-Zr-Mg alloy

Cu-Cr-Zr-Mg合金

1.

Research on aging microstructure and properties of Cu-Cr-Zr-Mg alloy;

Cu-Cr-Zr-Mg合金時效組織與性能

2.

Effects of different solution methods on aging properties of Cu-Cr-Zr-Mg alloy;

固溶時效和快速凝固時效對Cu-Cr-Zr-Mg合金時效性能的影響

3.

The effect of two-step deforming and aging processes on the properties of Cu-Cr-Zr-Mg alloy for lead frame was investigated.

探討了引線框架Cu-Cr-Zr-Mg合金固溶后二級變形時效工藝對合金硬度和電導率等性能的影響規律。

2)  Cu-Cr-Zr-Mg-RE alloy

Cu-Cr-Zr-Mg-RE合金

1.

Microstructure and properties of aging Cu-Cr-Zr-Mg-RE alloy;

時效態Cu-Cr-Zr-Mg-RE合金的組織與性能

2.

Melting technique of Cu-Cr-Zr-Mg-RE alloy with high performance in air was discussed.

探討了高性能Cu-Cr-Zr-Mg-RE合金在大氣下的熔煉技術。

3)  Cu-Cr-Zr-Mg Alloy

Cu-Cr-Zr-Mg

1.

Vacuum Smelting-casting Process for Cu-Cr-Zr-Mg Alloy;

Cu-Cr-Zr-Mg合金真空熔鑄工藝研究

4)  Cu-Cr-Zr alloy

Cu-Cr-Zr合金

1.

Erosion wear behavior of Cu-Cr-Zr alloy in liquid-solid two-phase flow;

液固兩相介質流中Cu-Cr-Zr合金的沖蝕磨損行為

2.

Electrical sliding wear behavior of Cu-Cr-Zr alloy;

Cu-Cr-Zr合金電滑動磨損行為研究

3.

Effects of Ageing and Deformation on Properties of the Cu-Cr-Zr Alloy;

時效與形變對Cu-Cr-Zr合金性能的影響

更多例句>>

5)  Cr-Zr-Cu alloy

Cr-Zr-Cu合金

1.

The variations of microstructure of Cr-Zr-Cu alloy before and after deep cryogenic treatment(DCT) were observed and analyzed by means of optical microscope,TEM,XRD and so on.

通過研究發現,深冷處理使Cr,Zr粒子彌散析出,能使Cr-Zr-Cu合金出現孿晶結構,并且長時間的深冷處理使銅合金的XRD衍射峰值的強弱發生明顯的變化,即深冷處理使銅合金晶粒發生了轉動,出現了擇優取向。

6)  Al-Zn-Mg-Cu-Zr alloy

Al-Zn-Mg-Cu-Zr合金

1.

Effect of Sc on as-cast microstructures and mechanical properties of Al-Zn-Mg-Cu-Zr alloys;

Sc對Al-Zn-Mg-Cu-Zr合金鑄態組織和力學性能的影響

2.

Effects of electromagnetic casting on as-cast microstructures and solid solubility inside crystals of Al-Zn-Mg-Cu-Zr alloy

電磁鑄造對Al-Zn-Mg-Cu-Zr合金微觀組織及晶內固溶度的影響

3.

Optimum retrogression and reaging heat treatment of super-high strength Al-Zn-Mg-Cu-Zr alloy containing Sc

含Sc超高強Al-Zn-Mg-Cu-Zr合金的回歸再時效處理制度

更多例句>>

補充資料：A1-Cu-Co合金中十次對稱準晶單晶體及其衍射圖

A1-Cu-Co合金中十次對稱準晶單晶體及其衍射圖


　　‘ Al Cu—Co合金中十次對稱準晶墮晶體e1)及其衍射圈(z) 中國科學盹壘禹研覽聽供稿
　　

說明：補充資料僅用于學習參考，請勿用于其它任何用途。

參考詞條

Al-Mg-Cu-Sc-Zr合金  Al-Cu-Mg-Ag-Zr合金  Al-Li-Cu-Mg-Zr合金  Al-Zr-Mg-Cu鋁合金  2091Al-Li-Cu-Mg-Zr合金  Al-Cu-Mg-Mn-Zr合金  Cu-Cr-Zr-Y合金  Cu-Cr-Zr系合金  Cu-Cr-V-Zr-RE合金 

  本文關鍵詞：電磁鑄造對Al-Zn-Mg-Cu-Zr合金微觀組織及晶內固溶度的影響，，由筆耕文化傳播整理發布。