本文關鍵詞： CrTiAlN涂層 光發射譜 SDC冷作模具鋼 非平衡磁控濺射 磨損　出處：《中國有色金屬學報》2017年04期 　論文類型：期刊論文

【摘要】：在不同光發射譜(OEM)條件下,采用閉合場非平衡磁控濺射技術(CFUBMSIP)在SDC99冷作模具鋼表面沉積CrTiAlN涂層,采用X射線衍射儀(XRD)、顯微硬度儀、原位納米力學測試系統和銷盤摩擦磨損試驗機(POD)測試分析涂層的相結構、表面硬度以及耐磨損性能。結果表明:各條件下制備的CrTiAlN涂層均為FCC結構,且在(200)晶面擇優取向;光發射譜值為65時,制備的CrTiAlN涂層具有較高的表面承載能力以及膜基結合力,納米硬度和彈性模量分別為22.7 GPa和276.4 GPa;OEM65制備的CrTiAlN涂層較OEM70、OEM80制備的CrTiAlN涂層具有更低的摩擦因數和磨損率,表現出更佳的摩擦磨損性能。
[Abstract]:Under different optical emission spectra (OEMs), CrTiAlN coating was deposited on the surface of SDC99 cold die steel by closed field unbalanced magnetron sputtering technique, and the microhardness was measured by X-ray diffractometer. The phase structure, surface hardness and wear resistance of the coatings were analyzed by in-situ nano-mechanical testing system and pin disk friction and wear tester. The results showed that the CrTiAlN coatings prepared under various conditions were of FCC structure and preferred orientation on the crystal plane. When the optical emission spectrum is 65, the CrTiAlN coating has high surface bearing capacity and membrane adhesion. The nano-hardness and modulus of elasticity are 22.7 GPa and 276.4 GPaOOEM65, respectively. The CrTiAlN coating has lower friction coefficient and better wear rate than the CrTiAlN coating prepared with OEM70 and OEM80, showing better tribological and wear properties.
【作者單位】： 上海大學材料科學與工程學院;
【分類號】：TG174.4
，

本文編號：1501477