【摘要】：以刀具磨損體積與材料去除量之比作為刀具體磨損率,并以此作為刀具利用率的評價指標,與傳統的刀具磨損曲線對比,證明了用刀具體磨損率評價刀具磨損情況的可行性;通過車削二硅酸鋰玻璃陶瓷,研究了切削速度、進給量和切削深度對刀具體磨損率的影響。結果表明:隨著切削速度增加,刀具體磨損率先降低后升高;隨著進給量增加,刀具體磨損率降低;隨著切削深度增加,刀具體磨損率先上升后降低。同時,結合刀具磨損形貌和材料崩碎情況,分析了刀具磨損機理。
[Abstract]:The ratio of tool wear volume to material removal is taken as tool wear rate, and the tool utilization ratio is used as evaluation index. Compared with the traditional tool wear curve, the feasibility of tool wear evaluation by tool wear rate is proved. The effects of cutting speed, feed rate and cutting depth on the wear rate of the tool were studied by turning lithium disilicate glass ceramics. The results show that with the increase of cutting speed, the specific wear of the cutter decreases first and then increases; with the increase of feed rate, the specific wear rate of the cutter decreases; and with the increase of cutting depth, the specific wear of the tool increases first and then decreases. At the same time, the tool wear mechanism was analyzed according to the tool wear morphology and material breakage.
【作者單位】： 東北大學秦皇島分校;東北大學;
【基金】：國家自然科學基金(51275083)
【分類號】：TQ171.733

【相似文獻】

相關期刊論文 前3條

1 畢四龍;吳伯麟;;添加Nd_2O_3對高鋁瓷的耐磨性及結構影響[J];陶瓷;2014年04期

2 楊問波,劉通廣;流化床內顆粒磨損研究[J];北京輕工業學院學報;1998年03期

3 高萬夫,鄭雁軍,崔立山,李西明,陳亞南,于龍文;管道彎頭磨損特性的研究[J];石油化工高等學校學報;2003年04期

，

本文編號：2331902