本文選題：電鍍廢水 + 鎳��； 參考：《電鍍與涂飾》2017年03期

【摘要】：分別研究了電絮凝技術和三維電極技術對含鎳電鍍廢水的去除效果。在初始pH為3、初始鎳濃度為120.7 mg/L、電流密度為6 mA/cm~2、反應25 min的條件下,電絮凝技術的鎳去除率在90%以上�？疾炝擞绊懭S電極處理的因素,包括活性炭吸附、攪拌、電壓和進水鎳濃度。在操作電壓為6 V、反應120 min的條件下,三維電極技術可將初始鎳濃度為10 mg/L和20 mg/L的電鍍廢水分別降低至0.1 mg/L和0.2 mg/L以下。利用電絮凝-三維電極聯合技術處理含鎳電鍍廢水,運行7個周期內出水總鎳濃度均低于0.15 mg/L。
[Abstract]:The removal effect of electroflocculation and three-dimensional electrode on nickel-containing electroplating wastewater was studied. When the initial pH is 3, the initial nickel concentration is 120.7 mg / L, the current density is 6 Ma / cm ~ (-2) and the reaction is 25 min, the removal rate of nickel by electroflocculation is over 90%. The factors affecting three dimensional electrode treatment, including activated carbon adsorption, agitation, voltage and influent nickel concentration, were investigated. Under the condition of operating voltage of 6 V and reaction of 120 min, the electroplating wastewater with initial nickel concentration of 10 mg/L and 20 mg/L can be reduced to 0. 1 mg/L and 0. 2 mg/L, respectively. The electroflocculation-three dimensional electrode technique was used to treat nickel electroplating wastewater. The total nickel concentration in effluent was lower than 0.15 mg / L during 7 cycles.
【作者單位】： 環境保護部華南環境科學研究所;廣州華科環保工程有限公司;
【基金】：國家科技重大專項項目(2014ZX07204-008)子課題:電鍍廢水中毒害污染物全過程控制技術研究與工程示范(2014ZX07204-008-002)
【分類號】：X781.1

【相似文獻】

相關期刊論文 前10條

1 陳武,李凡修,梅平;三維電極方法處理石油工業廢水COD的實驗研究[J];環境科學與技術;2001年S1期

2 曹瑩,周育紅,孫克寧,周德瑞;三維電極在水處理技術中的應用[J];黑龍江電力;2001年02期

3 蔣萌陽,朱建榮,戴靜波;復極性三維電極處理印染廢水的能耗分析[J];寧波工程學院學報;2005年02期

4 張斌,劉井軍,車玉泉;三維電極法處理印染廢水的實驗研究[J];吉林化工學院學報;2005年04期

5 郭玉鳳;王振川;李景印;李敏;王s，

本文編號：1892155