本文選題：粉煤灰 + 耐火材料��； 參考：《硅酸鹽通報》2017年04期

【摘要】：以云南省安寧市燃煤發電廠的粉煤灰為主要原材料,輔以生活污水處理廠的活性污泥和工業氧化鋁,對粉煤灰應用于耐火行業的可行性進行了理論分析,并通過XRD、SEM等手段進行驗證,在使其各項性能基本達標的基礎上,探索了粉煤灰耐火磚燒結的最佳溫度范圍,得到的結果主要有:粉煤灰的摻入量在68%左右,燒結溫度為1300℃時試樣氣孔率、吸水率,耐壓強度、抗折強度等性能參數達標。XRD結果顯示,1100~1300℃范圍內,隨著溫度的升高,莫來石波峰逐漸增多,峰值強度逐漸增強。SEM觀察發現,在1100~1300℃范圍內,隨著溫度的變化莫來石結構逐漸由針狀變柱狀,1300℃時莫來石結構更加緊密,1400℃時,莫來石結構松散,柱狀莫來石結構變少。
[Abstract]:Using fly ash from coal fired power plant in Anning City, Yunnan Province as the main raw material, and with activated sludge and industrial alumina from domestic sewage treatment plant, the feasibility of the application of fly ash in refractory industry is theoretically analyzed.By means of XRDX SEM and other means, the optimum sintering temperature range of fly ash refractory brick was explored on the basis of making its properties basically up to standard. The main results were as follows: the content of fly ash was about 68%,When the sintering temperature was 1300 鈩，

本文編號：1748407