本文選題：非水解溶膠-凝膠法　切入點：鈦酸鋁　出處：《人工晶體學報》2017年08期

【摘要】：本文采用非水解溶膠-凝膠(NHSG)法制備鈦酸鋁纖維。利用DTA-TG、XRD、TEM、SEM、FE-SEM等測試手段研究了鈦酸鋁的物相轉變過程,探討了助紡劑種類及其用量對制備鈦酸鋁纖維的影響。結果表明:采用NHSG法在750℃便能形成鈦酸鋁晶相,溶劑DBE和助紡劑環氧樹脂的引入沒有影響鈦酸鋁的低溫合成;環氧樹脂作為助紡劑有利于在溶膠中形成線性膠粒,提高溶膠的可紡性;環氧樹脂的添用量對鈦酸鋁纖維的制備影響較大,其用量為1∶1時,可制得表面光滑、結構致密,質量較好的鈦酸鋁纖維。
[Abstract]:In this paper, aluminum titanate fibers were prepared by unhydrolyzed sol-gel method. The phase transition process of aluminum titanate was studied by means of DTA-TGX, XRDX, Tem, SEME-SEM, etc. The effects of spinning aids and their dosage on the preparation of aluminum titanate fiber were discussed. The results showed that the crystalline phase of aluminum titanate could be formed by NHSG method at 750 鈩，

本文編號：1677623