本文選題：放電等離子燒結　切入點：六硼化鈰　出處：《功能材料》2017年08期 　論文類型：期刊論文

【摘要】：采用放電等離子燒結技術(SPS)制備了高致密度CeB6多晶塊體,考察了燒結工藝參數對多晶CeB6樣品性能的影響。結果表明,隨著燒結溫度和燒結壓力的升高,樣品的致密度逐漸增大,力學性能顯著提升。最佳燒結工藝參數為T=1 900℃,P=50 MPa,t=5 min,該工藝下多晶CeB6樣品的致密度為95.88%,硬度為(19.37±0.65)GPa,抗彎強度為(124.82±6.24)MPa。分別在1 500,1 600,1 700℃條件下,測試了該樣品的熱發射電流密度,結果表明隨著陰極溫度的升高,多晶CeB6的最大熱電子發射電流密度從3.14 A/cm2上升到18.45A/cm2,最小逸出功為3.05eV。
[Abstract]:High density CeB6 polycrystalline bulk was prepared by spark plasma sintering (SPS). The effects of sintering process parameters on the properties of polycrystalline CeB6 samples were investigated. The results showed that the density of the samples increased with the increase of sintering temperature and sintering pressure. The mechanical properties were improved significantly. The optimum sintering process parameters were: TX 1 900 鈩，

本文編號：1637799