本文選題：X射線熒光光譜法 + 主次成分　； 參考：《冶金分析》2017年12期

【摘要】：針對鉻礦主次組分同時測定中存在的問題,建立了熔融制樣-X射線熒光光譜法同時測定鉻礦中Cr_2O_3、Fe、MgO、SiO_2、Al_2O_3、CaO、P、S、K_2O、Ni、Co、Ti、Mn、V等14種主次組分的分析方法。以Li_2B_4O_7-LiBO_2(m∶m=67∶33)為熔劑,稀釋比1∶20,定量加入氧化-脫模混合溶液(500g/L NaNO_3溶液-70g/L LiBr溶液),在700℃預氧化5min,在1100℃熔融20min,制得透明的熔片。使用鉻礦標準物質與釩鈦鐵精礦標準物質,光譜純?cè)噭┭趸嚢床煌壤旌现苽浜铣尚?zhǔn)樣品系列,拓展了校準曲線含量范圍。方法的檢出限為10~748μg/g。采用理論α系數法和經驗系數法相結合的方法校正基體效應。對1個鉻礦樣品進行精密度考察,測定結果的相對標準偏差(RSD,n=12)均小于5%;采用實驗方法對1個鉻礦標準物質進行分析,測定結果與認定值相符,能滿足鉻礦中各成分的檢測要求。
[Abstract]:In order to solve the problems in simultaneous determination of main and minor components of chromium ores, a method for simultaneous determination of Cr2O3FeO- MgO- SiO- SiO2-Al2O3- Al2O3CaO- PSCOK2O-NiCoCoTiMnMnV and other major components in chromium ores by means of melting sample preparation and X-ray fluorescence spectrometry has been established. Using Li2B4Ostit _ 7-LiBO2M: M _ (67: 33) as flux, dilution ratio 1: 20, quantitative addition of 500g / L NaNO_3 solution -70g / L LiBr solution, preoxidation at 700 鈩，

本文編號：1911619