【摘要】：為研究回灌比例對好氧生物反應器填埋場穩定化進程的影響,探討了回灌比例為15%、20%、25%、30%和全回灌(體積分?jǐn)?shù))時,反應器所產滲濾液及填埋垃圾性質在不同回灌比例下變化的趨勢,填埋周期為198 d。結果表明:回灌比例為25%的反應器所產滲濾液中的氨氮于135 d達到GB 16889-2008所規定的垃圾填埋場滲濾液氨氮排放濃度限值,較其他反應器提前3~49 d,整個填埋周期所產還原性有機物較其他回灌量低2.11%~20.16%;且有機垃圾降解速度最快,至填埋結束時,沉降率為75.13%,比其他反應器多0.87%~2.63%,總有機質和纖維素含量分別為48.47%和7.39%,較其他回灌比例分別低0.61%~5.52%和0.2%~0.64%,表明25%的回灌比例有利于快填埋場的穩定化進程。
[Abstract]:In order to study the effect of recharge ratio on stabilization process of aerobic bioreactor landfill site, the tendency of the leachate produced by the reactor and the properties of landfill under different recharge ratios was discussed when the recharge ratio was 15% and 25% and 30% respectively, and the total recharge (volume fraction) was 30%. The landfill period is 198 days. The results showed that the ammonia nitrogen in leachate produced by the reactor with 25% recharge ratio reached the limit of ammonia nitrogen emission from landfill leachate prescribed by GB 16889-2008 in 135 days. Compared with other reactors, the amount of reducing organic matter produced in the whole landfill cycle was 2.11% and 20.16 days earlier than that in other reactors, and the degradation rate of organic waste was the fastest until the end of landfill. The settling rate was 75.13, 0.87% and 2.63 more than other reactors. The total organic matter and cellulose content were 48.47% and 7.39%, respectively, which were 0.61% and 0.22% lower than those of other recharge, indicating that 25% recharge ratio was beneficial to the stabilization process of the fast landfill site.
【作者單位】： 西南交通大學生命科學與工程學院;中鐵西北科學研究院有限公司西南分院;西南交通大學地球科學與環境工程學院;
【基金】：四川省科技支撐計劃項目(2015NZ0097) 甘肅省科技支撐計劃項目(1504FKA058)
【分類號】：X705

【相似文獻】

相關期刊論文 前10條

1 馬向東;;城市生活垃圾滲濾液特性研究[J];科技信息;2009年22期

2 袁怡祥;馬人熊;譚春青;楊征;劉佳;;滲濾液蒸發處理技術的難點與對策[J];環境工程;2009年06期

3 易凱;;榕江縣城生活垃圾衛生填埋處理工程滲濾液收集與處理系統設計[J];貴州化工;2011年01期

4 齊越;李啟彬;李光倜;李潔;;模擬生物反應器填埋場回灌滲濾液運移特性研究[J];環境科技;2013年04期

5 方明成,杜樹偉,王興全,杭世s，

本文編號：2141858