本文選題：熔渣 + 顯熱　； 參考：《工程科學學報》2016年10期

【摘要】：采用熱態改質方法可直接將冶金熔渣制備成高附加值材料,從而實現熔渣的"熱""渣"雙利用,因此這一方法在熔渣資源化利用領域中已成為研究熱點.本文選取熔融鋼渣和河沙分別為典型熔渣和改質劑,模擬計算分析在1600℃熔渣內摻入改質劑的過程中改質劑摻量對改質熔渣顯熱的影響,并對研究結果進行工業試驗驗證.研究表明:隨著改質劑摻入,改質熔渣顯熱呈現先增加后減小的趨勢;隨改質劑摻量由5%增加到11%時改質熔渣顯熱反而增加,當改質劑摻量為11%時改質熔渣顯熱達到最大.從熔渣顯熱利用和改質效果綜合考慮,改質劑摻量的理論最佳區間為11%~19%.現場試驗表明,摻入12%左右的河沙后,改質熔渣流動性好,冷卻渣安定性等性能改善顯著.
[Abstract]:The metallurgical slag can be directly prepared into a high value-added material by means of hot state modification, thus realizing the double utilization of "hot" slag "of molten slag. Therefore, this method has become a research hotspot in the field of slag resource utilization. In this paper, molten steel slag and river sand are selected as typical slag and modifier, respectively, and the effect of the amount of modifier on the sensible heat of modified slag during the process of adding modifier into slag at 1600 鈩，

本文編號：1875067