折流人工濕地模擬裝置的水力特性研究
發布時間:2018-03-10 16:28
本文選題:折流人工濕地 切入點:水力特性 出處:《環境科學與技術》2016年11期 論文類型:期刊論文
【摘要】:為研究折流人工濕地的水力特性,構建了一系列不同長寬比和折流模式的人工濕地模擬裝置(簡稱裝置),通過示蹤實驗得到停留時間分布密度圖(簡稱RTD曲線),并計算裝置的水力特性參數。結果表明,長寬比2∶1的水平推流裝置的回收率為遠遠小于長寬比4:1的水平推流裝置,說明過小的長寬比會引起滯留現象。水平折流裝置在無基質填充時,水力特性與水平推流裝置基本相同,在填充基質后,回收率急劇下降到20%以下,水力特性反而變差。四廊道上下折流裝置與其他裝置相比顯著減少了死區,同時保證較高的回收率(1.5 h內64.56%),具有較滿意的水力特性。
[Abstract]:In order to study the hydraulic characteristics of diversion constructed wetland, A series of artificial wetland simulation devices with different aspect ratio and baffle mode were constructed. The residence time distribution density map (RTD curve) was obtained by tracer experiment, and the hydraulic characteristic parameters of the device were calculated. The recovery rate of horizontal push flow device with aspect ratio of 2: 1 is much lower than that of horizontal push flow device with aspect ratio of 4: 1, which shows that too small aspect ratio will cause retention. The hydraulic characteristic is basically the same as the horizontal pushing device. After filling the matrix, the recovery rate drops sharply below 20%, and the hydraulic characteristic becomes worse. At the same time, a high recovery rate of 64.56% is guaranteed within 1.5 h, which has satisfactory hydraulic characteristics.
【作者單位】: 上海交通大學環境科學與工程學院;
【基金】:國家水體污染控制與治理科技重大專項(2012ZX07105-002-03) 交通部科技項目(2009-353-333-340)
【分類號】:X703
【相似文獻】
相關期刊論文 前6條
1 賴翼峰;某排污擴散器水力特性的實驗研究[J];上海環境科學;1995年05期
2 孫凌凌;俞從正;;圓柱形ABR反應器在不同HRT下的水力特性研究[J];陜西科技大學學報(自然科學版);2012年03期
3 侯晨雯;俞從正;馬興元;王穎;;新型結構ABR的設計與水力特性研究[J];環境工程學報;2011年02期
4 樓菊青;;新型移動床生物膜反應器水力特性的研究[J];環境科學與技術;2007年09期
5 樊紀湘;液位自動控制閥的水力特性[J];化工給排水設計;1997年02期
6 ;[J];;年期
相關碩士學位論文 前1條
1 耿亞鴿;厭氧折流板反應器的水力特性實驗與流場模擬研究[D];鄭州大學;2008年
,本文編號:1594145
本文鏈接:http://sikaile.net/kejilunwen/huanjinggongchenglunwen/1594145.html
最近更新
教材專著