【摘要】：介紹了某型號超臨界汽輪機紅套環高壓內缸強度有限元分析方法,對紅套環高壓內缸額定負荷穩態工況以及冷態啟動、溫態啟動、熱態啟動和極熱態啟動等瞬態工況進行了強度計算與分析,得出了紅套環高壓內缸額定負荷穩態工況和瞬態工況下的溫度場分布和最大應力比,并提出了該汽輪機的優化運行措施.結果表明:紅套環高壓內缸開裂部位瞬態工況下的應力過大是產生裂紋的主要原因之一;推薦的優化運行措施包括該汽輪機應多帶基本負荷,減少機組啟停次數,降低啟動過程中負荷在29%~56%內主蒸汽的升溫率,特別應降低負荷在53%~56%內主蒸汽的升溫率.
[Abstract]:This paper introduces the finite element analysis method of high pressure inner cylinder strength of red sleeve ring high pressure inner cylinder of a certain type of Supercritical steam turbine. The strength calculation and analysis are carried out under the rated load steady state and transient conditions such as cold start, warm start, hot start and extreme hot start. The temperature field distribution and maximum stress ratio under rated load steady and transient conditions of red ring high pressure inner cylinder are obtained. The optimal operation measures of the steam turbine are put forward. The results show that the excessive stress at the cracking position of the high pressure inner cylinder of the red ring is one of the main causes of the crack, and the recommended optimal operation measures include that the turbine should carry more basic load, reduce the number of start-up and shutdown of the unit, reduce the heating rate of the main steam within 29% 鈮，

本文編號：2518661