【摘要】：以GT Solar公司DSS~(TM)450型多晶硅鑄錠爐為例,建立了鑄錠爐熱場的三維熱學模型,由此計算并獲得了爐內的三維熱場分布,發現熱場呈三維分布,而不是簡單的二維軸對稱分布;比較了4種不同功率分配方案的熱場分布,發現提高頂部加熱器的功率配比對溫度不均勻性有一定的改善,但卻會使加熱效率大大下降;對冷卻板內的溫度分布也進行了數值模擬,發現支撐柱對熱場有重要影響。
[Abstract]:Taking the DSS~ (TM) 450 polycrystalline silicon ingot furnace of GT Solar Company as an example, a three-dimensional thermal model of the ingot furnace is established. From this model, the three-dimensional thermal field distribution in the furnace is calculated and obtained. It is found that the thermal field is a three-dimensional distribution. Instead of a simple two-dimensional axisymmetric distribution; The thermal field distribution of four different power distribution schemes is compared. It is found that increasing the power ratio of the top heater can improve the temperature inhomogeneity to some extent, but it will greatly decrease the heating efficiency. The temperature distribution in the cooling plate is also numerically simulated, and it is found that the supporting column has an important effect on the thermal field.
【作者單位】： 上饒師范學院江西省塑料制備成型重點實驗室;理想能源設備(上海)有限公司;晶科能源有限公司;
【基金】：國家自然科學基金資助項目(11404214) 江西省教育廳科技落地計劃項目(KJLD12046)
【分類號】：TN304.12

【相似文獻】

相關期刊論文 前1條

1 王倩;鐘傳杰;;IGBT二維溫度分布及熱穩定因子的研究[J];電子器件;2008年06期

，

本文編號：2397611