【摘要】：隨著大量電力電子投入到電網中運行,電網諧波分量比例越來越大、功率因數越來越低,而且還會產生電壓波動、閃變、三相不平衡等嚴重電能質量問題,因此諧波治理刻不容緩。諧波治理的最佳方案是在企業的廠內變電站或大型車間配電間安裝使用有源電力濾波器。本文研究分析相關產品標準JB/T 11067-2011、YD/T 2323-2011、JG/T 417-2013、DL/T 1216-2013,整理出試驗?zāi)康呐c要求。又對比分析了標準推薦的三相不控整流電路和三相全控整流電路所產生的諧波特點,發現推薦的三相不控整流電路僅有6n±1次的諧波,而三相全控整流電路的諧波則豐富很多,并且各含量比例可由觸發角進行調節,因此確定本系統采用三相全控整流電路做諧波源負載。為了更好地完成有源濾波器產品試驗檢測,本文在研究產品技術參數和各參數試驗方法的基礎上,設計了一套有源電力濾波器產品自動檢測系統。檢測系統將試驗線路、測試儀器設備、試驗步驟等集中納入自動檢測系統,通過電腦界面上的設置和按鈕操作完成試驗,同時試驗數據也由通信傳上來,便于整理試驗報告。最后使用該系統完成有源濾波器試驗,并對試驗結果進行整理評定。
[Abstract]:As a large number of power electronics are put into operation, the proportion of harmonic components in the power network becomes larger and larger, the power factor is lower and lower, and there are also serious power quality problems, such as voltage fluctuation, flicker, three-phase imbalance and so on. Therefore, harmonic management is urgent. The best way to control harmonics is to install active power filter in the substation or distribution room of large workshop. In this paper, the related product standard JB/T 11067-2011a YD / T 2323-2011 / JG / T 417-2013 DL / T 1216-2013 is analyzed, and the purpose and requirements of the test are sorted out. The harmonic characteristics of standard three-phase non-controlled rectifier circuit and three-phase full-control rectifier circuit are compared and analyzed. It is found that the recommended three-phase non-controlled rectifier circuit has only 6n 鹵1 order harmonics, while the three-phase fully controlled rectifier circuit has a lot of harmonics. And the proportion of each content can be adjusted by the trigger angle, so it is determined that the three-phase full-control rectifier circuit is used as the harmonic source load. In order to complete the testing of active power filter (APF) products, a set of automatic detection system for APF products is designed based on the study of the technical parameters of the products and the test methods of each parameter. The test system integrates the test circuit, test equipment and test steps into the automatic test system, and completes the test by setting the computer interface and the operation of the button. At the same time, the test data is also transmitted from the communication to facilitate the arrangement of the test report. Finally, the system is used to complete the active filter test, and the test results are collated and evaluated.
【學位授予單位】：河北工業大學
【學位級別】：碩士
【學位授予年份】：2015
【分類號】：TN713.8;TM761

【參考文獻】

相關期刊論文 前1條

1 陳國柱,呂征宇,錢照明;典型工業電網諧波及其混合有源濾波抑制[J];電網技術;2000年05期

，

本文編號：2355784