本文選題：太陽電池 + 擴散��； 參考：《計算機仿真》2014年12期

【摘要】：針對太陽能電池?cái)U(kuò)散區無法準確測量的困難,應用仿真軟件可以更好的研究太陽能電池?cái)U(kuò)散區。應用SILVACO軟件對太陽電池的兩步擴散工藝進行了仿真研究,探索了不同的二次擴散工藝方法對太陽電池性能和擴散區結構的影響。分別對濕法氧化擴散工藝、二氧化硅保護擴散工藝和無氧擴散工藝進行仿真設計。仿真結果表明,濕法氧化二次擴散工藝可以提高電池的表面雜質濃度,形成較淺的PN結。通過對三種不同工藝電池光譜響應的仿真,發現應用濕法氧化二次擴散工藝可以獲得最佳光譜響應性能。通過對濕法氧化二次擴散工藝的擴散溫度、預淀積濃度的研究,發現隨著二次擴散溫度的增加,電池的短路電流先增加后降低;隨著預淀積濃度的增加,電池的短路電流先增加后降低。
[Abstract]:In view of the difficulty that the diffusion zone of solar cells can not be measured accurately, the application of simulation software can better study the diffusion zone of solar cells. The two-step diffusion process of solar cells was simulated by using SILVACO software. The effects of different secondary diffusion processes on the performance and diffusion zone structure of solar cells were explored. The wet oxidation diffusion process, silica protective diffusion process and non-oxygen diffusion process were simulated and designed respectively. The simulation results show that the secondary diffusion process of wet oxidation can increase the concentration of impurity on the surface of the battery and form a shallow PN junction. Through the simulation of the spectral response of three different processes, it is found that the optimum spectral response can be obtained by using the wet oxidation secondary diffusion process. Through the study of the diffusion temperature and the pre-deposition concentration of the wet oxidation secondary diffusion process, it is found that with the increase of the secondary diffusion temperature, the short-circuit current of the battery increases first and then decreases, and with the increase of the pre-deposition concentration, The short circuit current of the battery first increases and then decreases.
【作者單位】： 常熟理工學院物電學院;
【基金】：國家自然科學青年基金項目(51205212)
【分類號】：TM914.4
，

本文編號：1878307