本文選題：D-STATCOM + 蓄電池充放電�。� 參考：《廣西大學》2014年碩士論文

【摘要】：配電網靜止同步補償器(D-STATCOM)能有效解決配電網中電壓波動問題。本文針對三相平衡配電系統,研制D-STATCOM裝置及其DSP控制器,并將其應用到蓄電池充放電系統的電壓穩定控制。從D-STATCOM電路的數學建模出發,采用勞斯判據對系統進行穩定性分析,說明D-STATCOM系統是可控的。分析D-STATCOM的穩壓原理,通過仿真驗證穩壓方案的可行性。在此基礎上,重點對D-STATCOM穩壓裝置進行了硬、軟件設計。硬件設計主要包括IGBT光電隔離及驅動、信號調理、故障保護、PWM輸出緩沖、控制電源、繼電保護等電路；軟件設計主要包括初始化、AD采樣和控制算法等程序,并進行了閉環運行測試。在此基礎上,搭建D-STATCOM蓄電池充放電-無功穩壓實驗樣機。對系統中主電路結構、器件參數選擇進行分析,對系統整體控制算法進行了研究。在實驗室提供條件下,做了D-STATCOM無功穩壓系統實驗,對實驗結果進行了詳細分析,結果表明D-STATCOM裝置能夠保持蓄電池充放電系統交流母線電壓穩定。
[Abstract]:The static synchronous compensator D-STATCOMcan effectively solve the voltage fluctuation problem in distribution network. In this paper, a D-STATCOM device and its DSP controller are developed for three-phase balanced distribution system, and applied to voltage stability control of battery charging and discharging system. Based on the mathematical modeling of D-STATCOM circuit, the stability of the system is analyzed by using the Rouse criterion, which shows that the D-STATCOM system is controllable. The principle of D-STATCOM voltage stabilization is analyzed, and the feasibility of voltage stabilization scheme is verified by simulation. On this basis, the hardware and software design of D-STATCOM voltage regulator is emphasized. The hardware design mainly includes IGBT photoelectric isolation and drive, signal conditioning, fault protection, PWM output buffer, control power supply, relay protection, etc. The software design mainly includes initialization AD sampling and control algorithm, etc. The closed loop running test is also carried out. On this basis, the D-STATCOM battery charge and discharge-reactive power stable experimental prototype. The structure of the main circuit and the selection of the device parameters are analyzed, and the overall control algorithm of the system is studied. Under the conditions provided by the laboratory, the D-STATCOM reactive power steady voltage system experiment is done, and the experimental results are analyzed in detail. The results show that the D-STATCOM device can keep the AC bus voltage of the battery charging and discharging system stable.
【學位授予單位】：廣西大學
【學位級別】：碩士
【學位授予年份】：2014
【分類號】：TM912
，

本文編號：1779318