本文選題：開關電源　切入點：高頻高壓　出處：《山東大學》2015年碩士論文　論文類型：學位論文

【摘要】：雙極性高頻高壓方波電源是一種體積小,重量輕,精度高,動態響應快,技術含量高的開關電源,這些也基本是這類電源的主要特點,方波電源開關頻率在40kHz左右。目前,高頻高壓交流電源涉足到諸多領域,應用前景十分廣泛,在科研試驗方面應用尤其突出,如：電力電纜、電力電容器耐壓試驗；靜電除塵；放電水處理等。對高頻高壓交流電源的研究有很多,但對雙極性高頻高壓方波源的研究卻是甚少。本文對雙極性高頻高壓方波源的基本工作原理、電路結構進行了分析,旨在研制一臺頻率為100-100kHz可調、幅值10kV的雙極性高頻高壓方波源。本文主要介紹了典型高頻高壓方波電源的工作原理,該電源主要由幾部分組成,包括：整流電路、升壓斬波電路和高頻逆變電路等環節,簡單分析了全控型器件IGBT的工作原理和脈沖寬度調制技術的基本思想。據此設計了高頻高壓方波電源實物,并利用PSIM仿真軟件對電源設計的主電路各部分如整流濾波電路、升壓斬波電路、逆變電路等做了詳細的仿真分析,重點為整流斬波電路增加負反饋穩壓控制系統,做出了電路優化。最后通過實驗的方法,對設計出的電路分兩部分進行了實驗分析：逆變電路和帶反饋的整流穩壓電路,其中針對逆變電路做出了能基本實現設計要求的電路板,并進行了相關的波形分析。實驗制作基本的電路板結構,經驗證基本滿足要求。
[Abstract]:Bipolar high frequency and high voltage square wave power supply is a kind of switching power supply with small volume, light weight, high precision, fast dynamic response and high technology content. These are also the main characteristics of this kind of power supply. The switching frequency of square wave power supply is about 40 kHz. High frequency and high voltage AC power supply is involved in many fields, and its application prospect is very extensive, especially in scientific research and test, such as: power cable, power capacitor withstand voltage test, electrostatic dusting; The research of high frequency and high voltage AC power supply is much, but the research of bipolar high frequency and high voltage square wave source is very few. In this paper, the basic working principle and circuit structure of bipolar high frequency and high voltage square wave source are analyzed. In order to develop a bipolar high-voltage square wave source with adjustable frequency 100-100kHz and 10kV amplitude, this paper mainly introduces the working principle of typical high-frequency high-voltage square wave power supply, which is mainly composed of several parts, including: rectifier circuit. In this paper, the working principle of full control device IGBT and the basic idea of pulse width modulation technology are simply analyzed in the aspects of boost chopper circuit and high frequency inverter circuit. Based on this, the high frequency and high voltage square wave power supply is designed. The main circuit of power supply design such as rectifier filter circuit, boost chopper circuit, inverter circuit and so on are simulated and analyzed in detail by using PSIM simulation software. The emphasis is that rectifier chopper circuit increases negative feedback voltage stabilizing control system. Finally, through the experimental method, the designed circuit is divided into two parts: the inverter circuit and the rectifier circuit with feedback. The circuit board which can basically realize the design requirement is made for the inverter circuit, and the related waveform analysis is carried out. The basic circuit board structure is made by experiment, and it is proved that the circuit board meets the requirements basically.
【學位授予單位】：山東大學
【學位級別】：碩士
【學位授予年份】：2015
【分類號】：TM46

【參考文獻】

相關期刊論文 前3條

1 錢照明,張軍明,呂征宇,彭方正,汪i襠，

本文編號：1622932