脫硝催化劑失活及再生實驗
發布時間:2018-10-26 12:19
【摘要】:以某電廠失活和再生催化劑為研究對象,采用全尺寸催化劑性能檢測臺和比表面積儀、X射線熒光光譜儀、X射線衍射光譜儀、掃描電鏡等儀器對催化劑進行了性能檢測和表征分析。結果表明:2層催化劑經過24 000 h脫硝運行后,不能滿足脫硝效率≥83.0%且氨逃逸量≤3?L/L的設計要求,催化劑相對活性為0.70;經再生處理后,催化劑孔道得到了疏通,各項指標恢復到新催化劑的水平,2層催化劑滿足設計脫硝效率和氨逃逸量要求的同時,有效控制了SO2/SO3轉化率;再生后催化劑相對活性提高到0.99,脫硝性能得到明顯改善。
[Abstract]:The deactivation and regeneration catalysts in a power plant were studied. The full-scale catalyst performance test bench, specific surface area meter, X-ray fluorescence spectrometer, X-ray diffraction spectrometer were used. The performance of the catalyst was tested and characterized by SEM and other instruments. The results showed that the two-layer catalyst could not meet the design requirements of denitrification efficiency 鈮,
本文編號:2295692
[Abstract]:The deactivation and regeneration catalysts in a power plant were studied. The full-scale catalyst performance test bench, specific surface area meter, X-ray fluorescence spectrometer, X-ray diffraction spectrometer were used. The performance of the catalyst was tested and characterized by SEM and other instruments. The results showed that the two-layer catalyst could not meet the design requirements of denitrification efficiency 鈮,
本文編號:2295692
本文鏈接:http://sikaile.net/kejilunwen/dianlidianqilunwen/2295692.html
最近更新
教材專著