SRX穩定碎石骨架密實級配及路用性能
發布時間:2018-02-10 12:47
本文關鍵詞: 道路工程 SRX穩定碎石 級配 垂直振動成型方法 出處:《建筑材料學報》2017年02期 論文類型:期刊論文
【摘要】:基于垂直振動成型方法(VVCM)研究了粗集料級配對其振實密度的影響,細集料級配對有機高分子聚合物SRX穩定細集料抗壓強度的影響,粗、細集料質量比及關鍵篩孔通過率對SRX穩定碎石抗壓強度的影響,以抗壓強度最大為原則提出了SRX穩定碎石骨架密實級配,并驗證了其路用性能.結果表明:當粒徑為19~37.5mm,9.5~19mm,4.75~9.5mm的粗集料質量比為48∶30∶22時,混合粗集料振實密度最大;當篩孔通過率的遞減系數I=0.65時,SRX穩定細集料抗壓強度最大;當粗、細集料質量比為65∶35時,SRX穩定碎石抗壓強度最大;當關鍵篩孔31.5,19,9.5,4.75,2.36,0.6,0.075mm通過率分別為95.0%~100.0%,64.0%~71.0%,44.0%~52.0%,32.0%~40.0%,22.0%~29.0%,11.0%~18.0%和5.0%~11.0%時,SRX穩定碎石抗壓強度最大;與規范級配和水泥碎石級配相比,骨架密實級配SRX穩定碎石抗壓強度、劈裂強度至少可分別提高13%和19%.
[Abstract]:Based on the vertical vibration molding method, the influence of coarse aggregate gradation on its vibrational density and the effect of fine aggregate gradation on the compressive strength of organic polymer SRX stabilized fine aggregate were studied. The effect of the mass ratio of fine aggregate and the pass rate of key sieve holes on the compressive strength of SRX stabilized macadam was studied. Based on the principle of maximum compressive strength, the dense gradation of SRX stabilized macadam framework was put forward. The results show that when the mass ratio of coarse aggregate is 48: 30: 22, when the coarse aggregate mass ratio is 48: 30: 22, the maximum vibrational density of mixed coarse aggregate is obtained, and the maximum compressive strength of SRX stabilized fine aggregate is obtained when the decreasing coefficient of pass ratio of sieve hole is Ig 0.65, and when the mass ratio of coarse aggregate is 48: 30: 22, the SRX stabilized fine aggregate has the highest compressive strength. When the mass ratio of fine aggregates is 65: 35, the compressive strength of SRX stabilized macadam is the highest; when the key sieve hole is 31.5199.752.750.36 / 2.36.0.60.75mm, the passing rate is 95.00.0100.0100.0100.0100.0100.052.032.040.052.029.011.0% and 5.0- 11.0mm respectively. Compared with the standard grade and cement crushed stone grade, the SRX stabilized crushed stone has the highest compressive strength. The compressive strength and splitting strength of SRX stabilized macadam with dense gradation of skeleton can be increased by at least 13% and 19, respectively.
【作者單位】: 長安大學特殊地區公路工程教育部重點實驗室;金華市公路管理局;
【基金】:浙江交通科技項目(2013H18)
【分類號】:U414
,
本文編號:1500548
本文鏈接:http://sikaile.net/kejilunwen/daoluqiaoliang/1500548.html
最近更新
教材專著