本文選題：粉末冶金　切入點：碳納米管　出處：《粉末冶金材料科學與工程》2017年04期 　論文類型：期刊論文

【摘要】：通過微波燒結與軋制相結合,制備碳納米管(carbon nanotube,CNTs)增強銅基復合材料(CNTs/Cu),對該材料的顯微組織、致密度、硬度和抗拉強度等進行分析與測試,并通過正交試驗優化工藝參數。結果表明:CNTs的最佳含量(質量分數)為2.0%,在燒結溫度為1 000℃,保溫時間為30 min條件下制備的2.0%CNTs/Cu復合材料,CNTs均勻分散在Cu基體中,CNTs與Cu基體結合良好,材料致密度達到98.09%,維氏硬度(HV)為372,屈服強度和抗拉強度分別達到234 MPa和344 MPa,比微波燒結純銅分別提高18%和24%左右。
[Abstract]:Carbon nanocarbon nanotubes (CNTs) reinforced copper matrix composites were prepared by microwave sintering and rolling. The microstructure, densification, hardness and tensile strength of the composites were analyzed and tested. The results show that the optimum content (mass fraction) of 1: CNTs is 2.0 and the sintering temperature is 1 000 鈩，

本文編號：1586225