【摘要】：滾動軸承在發生故障時其振動信號會出現調制現象。Teager能量算子相比于Hilbert變換在運算速度和解調精度方面具有明顯優勢,但其不能提供足夠高的分辨率來解調低頻調制信號,為此提出復調制細化譜分析方法。通過軸承故障模擬實驗,對采集的正常、內圈輕微、嚴重故障的軸承振動信號進行Teager能量算子解調,然后對其包絡進行復調制細化譜分析,得到軸承回轉頻率及其諧波,內圈故障特征頻率及其諧波、邊頻帶。隨著軸承內圈故障程度的增加,內圈故障特征頻率、邊頻帶的幅值明顯增大,可作為滾動軸承內圈點蝕故障特征參數。
[Abstract]:When the rolling bearing fails, the vibration signal of the rolling bearing will appear modulation phenomenon. Teager energy operator has obvious advantages in operation speed and demodulation accuracy compared with Hilbert transform, but it can not provide enough resolution to Demodulate low frequency modulation signal. In this paper, a complex modulation refinement spectrum analysis method is proposed. Through the bearing fault simulation experiment, the vibration signal of the bearing with normal, slight inner ring and serious fault is Demodulated by Teager energy operator, and then the envelope of the bearing is analyzed by complex modulation refinement spectrum, and the rotation frequency and harmonics of the bearing are obtained. Inner ring fault characteristic frequency and its harmonics, edge band. With the increase of the fault degree of the inner ring of the bearing, the characteristic frequency and the amplitude of the edge band of the inner ring of the bearing increase obviously, which can be used as the characteristic parameters of the pitting fault of the inner ring of the rolling bearing.
【作者單位】： 軍事交通學院軍用車輛工程技術研究中心;
【分類號】：TH133.33

【相似文獻】

相關期刊論文 前10條

1 胥永剛;陸明;謝志聰;;基于固有時間尺度分解的能量算子解調法及故障診斷應用[J];海軍工程大學學報;2013年01期

2 蔡權偉;魏平;肖先賜;;基于能量算子的單信道重疊信號盲分離方法[J];中國科學(E輯:信息科學);2008年04期

3 劉紅星,陳濤,屈梁生,李振武,于立柱;能量算子解調方法及其在機械信號解調中的應用[J];機械工程學報;1998年05期

4 楊e，

本文編號：2493960