潤滑介質對摩擦性能影響差異分析
發布時間:2018-05-21 17:27
本文選題:潤滑油 + 復合鋰基潤滑脂 ; 參考:《潤滑與密封》2017年07期
【摘要】:L-CKD150潤滑油和復合鋰基潤滑脂廣泛運用于石油裝備潤滑減磨。為研究2種潤滑介質對摩擦副摩擦磨損性能及磨損機制的影響差異,采用MMW-1型微機控制立式萬能摩擦磨損試驗機,開展不同接觸壓力和線速度及不同潤滑環境下摩擦學實驗研究。結果表明:實驗工況下,銷-盤摩擦副表面以磨粒磨損為主,同時存在黏著磨損;相比于L-CKD150潤滑工況,復合鋰基潤滑脂潤滑時銷-盤表面黏著磨損更為嚴重,進而加大摩擦因數的波動幅度,最大波動幅度為L-CKD150潤滑下的3.7倍;盤試樣表面磨粒磨損與接觸壓力有關,0.5 MPa接觸壓力下,L-CKD150潤滑時磨粒磨損較嚴重,1.5 MPa下則復合鋰基潤滑脂潤滑時更嚴重,磨粒磨損是影響盤試樣磨損量差異的主要因素。
[Abstract]:L-CKD150 lubricating oil and compound lithium grease are widely used in oil equipment lubrication and wear reduction. In order to study the influence of two kinds of lubricating media on friction and wear performance and wear mechanism of friction pair, MMW-1 microcomputer controlled vertical universal friction and wear tester was adopted. Tribological experiments under different contact pressure, linear velocity and lubricating environment were carried out. The results show that the surface of the pin-disk friction pair is mainly abrasive wear under the experimental condition, and there is adhesive wear at the same time, compared with the L-CKD150 lubricating condition, the pin-disc surface adhesion wear is more serious when the composite lithium grease is lubricated. Then the fluctuation range of friction coefficient is increased, the maximum fluctuation range is 3. 7 times as much as that under L-CKD150 lubrication. The abrasive wear on the surface of disk specimen is related to the contact pressure. The abrasive wear of L-CKD150 lubricated is more serious than that of compound lithium grease lubricated at 0. 5 MPa contact pressure. Abrasive wear is the main factor that affects the wear quantity of disc specimen.
【作者單位】: 西南石油大學機電工程學院;
【基金】:國家自然科學基金項目(51505397)
【分類號】:TH117
【參考文獻】
相關期刊論文 前6條
1 江澤琦;方建華;陳波水;吳江;鄭哲;劉宇航;李昊;;磁場作用下基礎油和含磷酸三甲酚酯潤滑油的摩擦磨損特性[J];摩擦學學報;2016年05期
2 何霞;廖文玲;王國榮;鐘林;蔣龍;;織構邊緣凸起對壓裂泵柱塞密封副摩擦性能的影響[J];潤滑與密封;2016年07期
3 趙磊;蔡振兵;張祖川;張旭;林映武;彭金方;朱e,
本文編號:1920103
本文鏈接:http://sikaile.net/jixiegongchenglunwen/1920103.html
最近更新
教材專著