本文選題：熒光漂白成像　切入點：微間隙　出處：《摩擦學學報》2017年04期

【摘要】：沿潤滑油膜厚度方向的剪切流速分布是影響機械部件潤滑性能的重要因素.為此,搭建了基于熒光漂白成像的微間隙油膜剪切流速分布測量平臺.通過對漂白區域形狀演化過程進行圖像分析,獲得了微米量級間隙中的PB450和PAO6潤滑油膜的剪切速度分布.結果表明:在設定測試條件下,厚度為8.5μm的PB450油膜沿膜厚方向的剪切流速近似為典型的線性分布,而相同厚度下的PAO6油膜流速分布表現為非線性塞流,界面附近油膜黏度較中層顯著下降.研究還發現,同一滑動速度下,PAO6剪切流速偏離線性分布的程度隨膜厚的降低而增加.經過比對分析,試驗結果與流體動壓潤滑條件下的相關數據吻合.
[Abstract]:The shear velocity distribution along the direction of lubricating oil film thickness is an important factor affecting the lubricating performance of mechanical components. A measuring platform of shear velocity distribution of microgap oil film based on fluorescence bleaching imaging was built. The shape evolution process of bleaching region was analyzed by image analysis. The shear velocity distribution of PB450 and PAO6 lubricating oil film in micron clearance is obtained. The results show that the shear velocity of PB450 oil film with thickness of 8.5 渭 m is approximately a typical linear distribution in the direction of film thickness under given test conditions. At the same thickness, the flow velocity distribution of PAO6 oil film is a nonlinear plug flow, and the viscosity of oil film near the interface is significantly lower than that of the middle layer. The deviation of shear velocity of PAO6 increases with the decrease of film thickness at the same sliding velocity. Through comparison and analysis, the experimental results are in good agreement with the relevant data under hydrodynamic lubrication.
【作者單位】： 青島理工大學機械工程學院;
【基金】：國家自然科學基金(51605239) 青島市應用研究項目(2016193)資助~~
【分類號】：TH117.2

【相似文獻】

相關期刊論文 前10條

1 伯納德·哈姆羅克 ,鄧肯·道森 ,柴大勇;計算最小潤滑油膜厚度[J];機床;1979年10期

2 鄭發正,謝鳳;潤滑油膜的形成和結構分析[J];合成潤滑材料;2001年01期

3 熊萬里;潤滑油膜電磁損傷故障的機理及防治方法[J];潤滑與密封;2004年06期

4 丁苗苗;長城潤滑油公司及潤滑油百余問題解答(十五)[J];摩托車;2005年03期

5 ;2007年潤滑油技能競賽中級模擬題[J];石油商技;2007年04期

6 梁培鈞;趙質良;;關于潤滑油衰變?cè)蚺c危害的探討[J];內燃機;2009年04期

7 張秋霞;劉朋;;潤滑油的性能及正確使用[J];科技信息;2012年34期

8 ;CCI 分離潤滑系統及其潤滑油泵[J];小型內燃機;1972年02期

9 Q每∥，

本文編號：1682393