本文關鍵詞： 能耗 液壓系統 功率匹配 能量轉換效率　出處：《合肥工業大學》2015年碩士論文　論文類型：學位論文

【摘要】：由于世界能源危機越來越引起人們的關注,隨之而來的節能問題也相應成為人們關注的焦點。在我國,由于工業所占比重很大,以高碳能源為主的工業能耗占全社會能量消耗的70%左右,造成高能耗的同時也增加了碳的排放,對我國節能環保產生了嚴重的影響。在人們節能意識普遍提高的條件下,以高碳能耗為特點的制造業正面臨節能的挑戰,本文以液壓成型裝備為節能研究對象,對其能耗特點進行分析,并結合液壓機工況對其能耗進行優化。 本文首先從液壓系統節能的角度對液壓機工作過程中的能耗特點進行了分析,分析結果表明,在液壓系統的實際能耗中,液壓泵和電機的能量轉換損失以及系統功率匹配不當造成的損失所占比例最大。本文在以解決液壓系統功率匹配損耗為目的的變頻節能理論基礎上,對變頻電機變量泵驅動方式的能耗進行理論優化分析。通過建立液壓系統變頻電機變量泵、變頻電機定量泵以及工頻電機變量泵三種驅動方式下的Simulink與AMESim聯合仿真模型,并對以上三種驅動方式的能耗進行比較,結果表明,以上三種驅動方式都能實現功率匹配的目的,但不同驅動方式下的液壓泵和電機的能量轉換效率不同,其中變頻電機變量泵驅動方式不僅滿足了液壓系統功率匹配的要求,同時也提升了液壓泵和電機的能量轉換效率。
[Abstract]:As the world energy crisis is getting more and more attention, the energy saving problem has become the focus of attention. In our country, because of the large proportion of industry. Industrial energy consumption, which is dominated by high carbon energy, accounts for about 70% of the total social energy consumption, which results in high energy consumption and also increases carbon emissions. Energy saving and environmental protection have a serious impact on our country. Under the condition that people's energy saving consciousness is raised generally, the manufacturing industry characterized by high carbon energy consumption is facing the challenge of energy saving. In this paper, hydraulic molding equipment is taken as the research object of energy saving. The characteristics of energy consumption are analyzed, and the energy consumption of hydraulic press is optimized. This paper first analyzes the characteristics of energy consumption in hydraulic press working process from the point of view of energy saving of hydraulic system. The analysis results show that in the actual energy consumption of hydraulic system. The energy conversion loss of hydraulic pump and motor and the loss caused by the improper power matching of the system account for the largest proportion. This paper is based on the theory of frequency conversion and energy saving aiming at solving the power matching loss of hydraulic system. The energy consumption of variable variable pump drive mode of variable frequency motor is optimized and analyzed theoretically. The variable variable pump of variable frequency motor of hydraulic system is established. The combined simulation model of Simulink and AMESim under three driving modes of variable variable pump and variable pump of frequency conversion motor is presented. The energy consumption of these three driving modes is compared and the results show that. The above three driving modes can achieve the purpose of power matching, but the energy conversion efficiency of hydraulic pump and motor under different driving modes is different. Variable-frequency motor variable pump drive not only meets the requirements of hydraulic system power matching, but also improves the efficiency of energy conversion between hydraulic pump and motor.
【學位授予單位】：合肥工業大學
【學位級別】：碩士
【學位授予年份】：2015
【分類號】：TM343;TH137

【參考文獻】

相關期刊論文 前10條

1 郎燕;李運華;;電液復合調節作動器的精確線性化建模與控制[J];北京航空航天大學學報;2009年09期

2 李永林;徐浩軍;曹克強;胡良謀;;航空柱塞泵全工況效率分析及熱力學建模[J];北京航空航天大學學報;2010年12期

3 張承慧,夏東偉,程兆林,李洪斌;變頻驅動注水系統效率優化問題的建模與控制[J];電工技術學報;2003年06期

4 楊洋,張桂香;基于MATLAB/SIMULINK的異步電機矢量控制調速系統仿真[J];湖南大學學報(自然科學版);2000年S1期

5 曹建偉,翁振濤,顧臨怡,凌鳳;基于工藝流程的液壓注塑機的變頻節能控制研究[J];機床與液壓;2003年06期

6 胡國慶;李世倫;葛耀崢;侯繼偉;顧臨怡;;海水柱塞泵的低泄漏高效率研究[J];機電工程;2011年05期

7 姚永明;劉順安;尚濤;陳延禮;周旭輝;;基于恒壓液壓系統的ZL50裝載機節能技術[J];吉林大學學報(工學版);2011年01期

8 楊尚平;楊曉玉;朱炎周;趙光波;;基于負載匹配的節流調速回路最大效率及計算模型[J];機械科學與技術;2010年03期

9 徐兵;張斌;林建杰;;變頻驅動液壓電梯系統能耗特性[J];機械工程學報;2006年08期

10 張紅娟;權龍;李斌;;注塑機電液控制系統能量效率對比研究[J];機械工程學報;2012年08期

，

本文編號：1463683