環境參數對蒸發式冷卻換熱器性能影響的實驗研究
發布時間:2019-02-16 14:35
【摘要】:本文利用由焓差室控制環境參數的水-水蒸發式冷卻換熱器實驗臺,研究噴淋密度、迎面風速和環境參數對其傳熱傳質性能的影響。當改變噴淋密度和迎面風速時,測得最佳噴淋密度為0.031 4 kg/(m·s),最佳迎面風速為3.22 m/s;在最佳噴淋密度和最佳迎面風速的條件下,改變環境參數,測得濕球溫度從22℃上升至28℃時,總傳熱系數降低約4.2%,傳質系數降低約9.3%;相對濕度從85%降低至55%時,總傳熱系數上升約10%,傳質系數上升約13.7%。
[Abstract]:In this paper, the influence of spray density, head-on wind speed and environmental parameters on the heat and mass transfer performance of water-water evaporative heat exchanger controlled by enthalpy difference chamber is studied. When the spray density and the face wind speed were changed, the optimum spray density was 0.031 kg/ (m s), and the best face velocity was 3.22 m / s; Under the condition of the best spray density and the best head-on wind speed, the total heat transfer coefficient and mass transfer coefficient are decreased about 4.2 and 9.3 respectively when the wet bulb temperature rises from 22 鈩,
本文編號:2424543
[Abstract]:In this paper, the influence of spray density, head-on wind speed and environmental parameters on the heat and mass transfer performance of water-water evaporative heat exchanger controlled by enthalpy difference chamber is studied. When the spray density and the face wind speed were changed, the optimum spray density was 0.031 kg/ (m s), and the best face velocity was 3.22 m / s; Under the condition of the best spray density and the best head-on wind speed, the total heat transfer coefficient and mass transfer coefficient are decreased about 4.2 and 9.3 respectively when the wet bulb temperature rises from 22 鈩,
本文編號:2424543
本文鏈接:http://sikaile.net/guanlilunwen/gongchengguanli/2424543.html
最近更新
教材專著