發布時間：2018-12-15 19:42

【摘要】：隨著空間技術的飛速發展,具有大口徑、高分辨率的空間望遠鏡在民用、商業、軍工、天文學等領域的作用越來越大。但是航天器上的運動設施(如控制力矩陀螺、反作用飛輪、太陽帆板展開機構、斯特林制冷機等)產生的微振動會極大的降低空間望遠鏡的成像質量。微振動形式復雜,具有幅值小、頻率分布范圍廣、振動多向等特點,同時大型空間望遠鏡技術復雜,涉及學科內容多,現有的振動抑制措施和分析技術很難滿足其發展需求,因此研究與之相關的微振動抑制技術、振動集成仿真分析、微振動地面模擬平臺等關鍵技術,對于大口徑空間望遠鏡的研制具有重要意義。設計了一種結構簡單的用于空間光學載荷在軌隔振的隔振器。分析了影響隔振器三向剛度的結構參數,針對不同的載荷,探討了隔振器的布置方式,并測試了其隔振性能。考慮到粘彈性阻尼材料的剛度和阻尼系數隨溫度和頻率變化的特性,介紹了一種基于復剛度的分析粘彈性阻尼材料的計算方法。試驗結果與分析值一致,表明文中關于隔振器的設計和分析方法有效、可靠,最后將該隔振器用于某一光學遙感器的隔振,分析結果表明該隔振器能有效抑制安裝面?zhèn)鬟f給光學遙感器的微振動。開展了多維微振動隔振系統在光學載荷整體隔振中的應用研究。建立了隔振系統的理論模型,得到廣義剛度矩陣和廣義阻尼矩陣。推導出計算多維隔振器固有頻率的數學解析式,并給出了優化隔振系統構型的優化方法。同時為評估隔振系統的隔振性能及分析微振動對光學載荷成像質量的影響,提出一種基于有限單元法的振動集成仿真分析方法,該方法在有限元中實現結構、光學、控制模型的集成,具有求解效率高、數據傳遞量小及計算精度高等優點。為模擬航天器上擾動源產生的微振動,提出了一種基于Gough—Stewart構型的微振動模擬平臺,并開展了兩代樣機的研制。分別利用牛頓——歐拉方法結合拉格朗日方程和凱恩方程建立了兩代模擬平臺的動力學方程,并利用ADAMS和Matlab/Simulink軟件進行多體系統的聯合仿真,驗證了理論模型的準確性。對第一代模擬平臺的工作性能進行了測試。根據測試結果,利用雙變量曲面擬合法對第一代模擬平臺的控制算法進行了修正,大大提升了其工作性能�？紤]到理論模型與實際模型之間的差異性,對微振動模擬平臺的控制策略進行了研究,提出一種基于動力學模型的PI魯棒控制。理論分析和仿真結果表明,該控制策略魯棒性強、穩定性好,能用于模擬平臺的加速度控制。
[Abstract]:With the rapid development of space technology, space telescopes with large aperture and high resolution are playing an increasingly important role in civil, commercial, military, astronomy and other fields. However, the micro-vibration generated by the motion facilities (such as the control moment gyroscope, the reaction flywheel, the solar panel unfurling mechanism, the Stirling refrigerator, etc.) will greatly reduce the imaging quality of the space telescope. The microvibration forms are complex, the amplitude is small, the frequency range is wide, the vibration is multi-directional and so on. At the same time, the technology of large space telescope is complex and involves many subjects, so the existing vibration suppression measures and analysis techniques are very difficult to meet its development needs. Therefore, it is of great significance for the development of large aperture space telescope to study some key technologies, such as micro-vibration suppression technology, vibration integrated simulation analysis, micro-vibration ground simulation platform and so on. A simple structure vibration isolator for space optical load in orbit is designed. The structural parameters affecting the three-dimensional stiffness of the isolator are analyzed. The layout of the isolator under different loads is discussed and its vibration isolation performance is tested. Considering that the stiffness and damping coefficient of viscoelastic damping materials vary with temperature and frequency, a calculation method based on complex stiffness for viscoelastic damping materials is introduced. The experimental results are in agreement with the analytical values, which show that the design and analysis method of the vibration isolator in this paper is effective and reliable. Finally, the isolator is applied to the vibration isolation of an optical remote sensor. The results show that this isolator can effectively suppress the micro vibration of the mounting surface transferred to the optical remote sensor. The application of multi-dimensional micro-vibration isolation system to the whole vibration isolation of optical load is studied. The theoretical model of the vibration isolation system is established, and the generalized stiffness matrix and the generalized damping matrix are obtained. The mathematical analytical formula for calculating the natural frequency of the multi-dimensional vibration isolator is derived, and the optimization method of the configuration of the vibration isolation system is given. In order to evaluate the vibration isolation performance of vibration isolation system and analyze the influence of micro vibration on the imaging quality of optical load, a vibration integrated simulation analysis method based on finite element method is proposed, which realizes the structure and optics in finite element method. The integration of control model has the advantages of high efficiency, low data transfer and high accuracy. In order to simulate the micro-vibration generated by the disturbance source on the spacecraft, a micro-vibration simulation platform based on Gough-Stewart configuration is proposed, and two generation prototypes are developed. Newton-Euler method combined with Lagrange equation and Kane equation are used to establish the dynamic equations of two generations of simulation platform, and the joint simulation of multi-body system using ADAMS and Matlab/Simulink software is carried out to verify the accuracy of the theoretical model. The performance of the first generation simulation platform is tested. According to the test results, the control algorithm of the first generation simulation platform is modified by using the bivariate surface fitting method, which greatly improves its performance. Considering the difference between the theoretical model and the practical model, the control strategy of the micro-vibration simulation platform is studied, and a dynamic model-based PI robust control is proposed. Theoretical analysis and simulation results show that the proposed control strategy is robust and stable, and can be used to control the acceleration of the platform.
【學位授予單位】：中國科學院研究生院(長春光學精密機械與物理研究所)
【學位級別】：博士
【學位授予年份】：2016
【分類號】：TB535.1

【相似文獻】

相關期刊論文 前10條

1 郭轉運,楊文霞;微振動的激光外差測量[J];大學物理;1985年11期

2 韓萬強;張明軒;;雙擺自由微振動分析[J];長江大學學報(自然科學版)理工卷;2009年01期

3 曹忠權,王好根,郭鐵拴;場地微振動及其強度特征分析[J];土工基礎;2003年02期

4 高曉萍;微振動馬達[J];光機電世界;1994年01期

5 蔣國偉;周徐斌;申軍烽;孔祥森;;衛星微振動虛擬仿真技術研究及應用[J];計算機測量與控制;2011年09期

6 葛東明;鄒元杰;張志娟;王澤宇;;基于全柔性衛星模型的控制閉環微振動建模與仿真[J];航天器工程;2012年05期

7 鄭佳明;王樣;張建潤;李雪琛;;電子廠房結構的微振動特性研究[J];潔凈與空調技術;2013年03期

8 高廣運;張博;李寧;;電子工業廠房微振動測試及數值分析[J];勘察科學技術;2011年03期

9 吳永權,張彪;高速公路對場地微振動背景影響的分析研究[J];華南地震;2005年03期

10 張巍;應祖光;;高技術設備隨機微振動環境評價指標[J];噪聲與振動控制;2010年01期

相關會議論文 前9條

1 叢波日;張曉春;鐘世英;;地鐵運行對臨近建筑微振動的影響分析[A];第九屆全國振動理論及應用學術會議論文集[C];2007年

2 叢波日;張曉春;鐘世英;;地鐵運行對臨近建筑微振動的影響分析[A];第九屆全國振動理論及應用學術會議論文摘要集[C];2007年

3 ，

本文編號：2381186