【摘要】：建立了閉式熱源塔的數學模型,利用MATLAB自編程序,實現了對噴淋工況下熱源塔的數值模擬,并將計算結果與實驗結果進行了比較。利用程序得到了噴淋工況下的閉式熱源塔內噴淋溶液、載熱流體、空氣焓值的分布,結果表明:塔內空氣焓值呈線性分布,翅片換熱器上半部分換熱效果比下半部分好,塔的中部位置附近最先出現結霜現象,空氣干球溫度高于5.1℃,相對濕度高于75%,閉式熱源塔熱泵系統沒有結霜風險,可以停止噴淋泵,有助減少熱泵系統的運行能耗。
[Abstract]:The mathematical model of the closed heat source tower is established, and the numerical simulation of the heat source tower under spray condition is realized by using MATLAB program, and the calculated results are compared with the experimental results. The distribution of spray solution, carrier heat fluid and air enthalpy in the closed heat source tower under spray condition is obtained by using the program. The results show that the air enthalpy in the tower is linearly distributed, and the heat transfer effect of the upper half of the finned heat exchanger is better than that of the lower half. The frosting phenomenon occurs first near the middle position of the tower. The air dry ball temperature is higher than 5.1 鈩，

本文編號：2486520