本文選題：提鈦尾渣　切入點：物相組成　出處：《武漢科技大學》2014年碩士論文　論文類型：學位論文

【摘要】：本文以提鈦尾渣、活性生石灰和工業鐵紅為原料制備出了鐵鋁酸鹽水泥熟料。具體研究?jī)?nèi)容包括： (1)研究了兩種緩冷提鈦尾渣的化學及物相組成，凝結時間和水化強度，并觀察了不同養護齡期水化產物的顯微形貌。結果表明，提鈦尾渣化學礦物組成和水化性能與鋁酸鹽水泥具有相似性，其主要水化物相是CA和CA2且水化過程類似CA50鋁酸鹽水泥。 (2)研究了配料比、煅燒溫度、保溫時間對急冷提鈦尾渣制備鐵鋁酸鹽水泥熟料的影響。結果表明，以提鈦尾渣、活性生石灰和工業鐵紅燒制鐵鋁酸鹽水泥熟料的工藝是可行的。最佳工藝參數為提鈦尾渣67wt%，，工業鐵紅15wt%，活性生石灰18wt%時，經過1250~1300℃保溫1h煅燒。 (3)研究了鐵鋁酸鹽水泥熟料的凝結時間、水化強度發展和不同齡期水化產物的顯微形貌。結果表明，實驗制備的鐵鋁酸鹽水泥熟料具有早強的特點。初凝時間為46min，終凝時間為87min，1d耐壓強度超過40MPa，但后期強度不理想。 (4)研究了鐵鋁酸鹽水泥熟料在高鋁澆注料中的應用性能，并與FONDU水泥、Secar71進行對比。結果表明，鐵鋁酸鹽水泥在高鋁澆注料中的結合強度發展與FONDU水泥相近，其110℃×24小時、1100℃×3小時熱處理后的強度發展與FONDU水泥接近但低于Secar71結合強度，1400℃×3小時熱處理后的強度高于后兩者。
[Abstract]:In this paper, iron aluminate cement clinker was prepared from titanium tailings, active quicklime and industrial iron red. 1) the chemical and phase composition, setting time and hydration strength of two slow-cooling titanium tailings were studied, and the micromorphology of hydration products at different curing ages were observed. The chemical mineral composition and hydration performance of titanium tailings are similar to those of aluminate cement. The main hydration phases are CA and CA2 and the hydration process is similar to that of CA50 aluminate cement. (2) the effects of proportioning ratio, calcination temperature and heat preservation time on the preparation of ferrite aluminate cement clinker from rapidly cooled titanium tailings were studied. The process of producing iron-aluminate cement clinker by activated lime and industrial iron red sintering is feasible. The optimum technological parameters are as follows: 67wtt tailings of titanium extraction, 15wtt of industrial iron red and 18wt% of activated quicklime, calcined at 1250,1300 鈩

本文編號：1577738