本文選題：低密度聚乙烯膜 + 柔性裝飾薄木��； 參考：《木材工業》2017年03期

【摘要】：為提高塑膜與薄木之間的界面膠合特性,采用低溫等離子體分別對塑膜和裝飾薄木的膠合面進行改性處理,制備塑膜增強紅櫟柔性裝飾薄木。優化工藝參數為:等離子體處理速度4 m/min,熱壓壓力0.6 MPa、溫度120℃、時間150 s;柔性裝飾薄木的剝離強度達0.52 k N/m,橫向抗拉強度達4.13 MPa,柔韌性卷曲鋼棒直徑可小至4 mm,浸漬剝離強度達到I類試驗要求,同時熱壓溫度明顯降低,減少了能耗。
[Abstract]:In order to improve the interfacial adhesion between plastic film and thin wood, plastic-film and decorative thin wood were modified by low temperature plasma to prepare flexible decorative wood. The optimized process parameters are as follows: plasma treatment rate is 4 m / min, hot pressing pressure is 0.6 MPA, temperature is 120 鈩，

本文編號：1881816