本文選題：水平井　切入點：偏心環空　出處：《西安石油大學》2017年碩士論文

【摘要】：在窄環空間隙中下套管、小井眼鉆進、深水鉆進和長水平段水平井鉆進等作業中,精確的波動壓力計算模型是準確預測井底壓力,避免井涌、井漏、井壁失穩等井下復雜情況發生的前提�，F(xiàn)場常用的波動壓力預測模型如Burkhardt模型和Schuh模型是針對于同心環空而建立的,而在水平井的斜井段和水平段,受重力因素和巖屑床的影響,會導致管柱在環空中處于偏心的位置。偏心環空和同心環空中波動壓力的計算方法不同,采用傳統的波動壓力計算方法會使得對于水平井井底波動壓力的預測偏大。針對以上問題,本文建立了適用于水平井的穩態和瞬態波動壓力計算模型。本文首先從影響波動壓力計算的因素出發,分析了在水平井的水平段偏心度對波動壓力的影響;提出了鉆井液流變參數擬合與流變模式優選的改進的黃金分割算法;分析了不同的鉆柱工作狀況下環空中流體的速度分布;并分析了鉆桿接頭、鉆井液的靜切力以及管柱加速度對波動壓力的影響。其次,針對水平井井筒中流體的穩態和瞬態流動狀態,分別建立了波動壓力的計算模型,在模型建立的過程中,考慮了不同的偏心度、鉆井液流變模式和管柱工作狀況。對模型的合理性進行了驗證,其中,4參數流體分別在同心環空中和偏心環空中流動的穩態波動壓力計算模型的計算結果和前人測量的多組實驗數據的誤差基本都在10%以內;瞬態波動壓力模型計算結果同Burkhardt和Clark各自測量的兩口井的現場測量數據的最大誤差分別為11.5%和9.93%。最后,根據所建立的水平井中波動壓力計算模型,利用Matlab語言編制了波動壓力計算軟件,并通過實例計算對波動壓力計算模型的參數敏感性進行了分析。分析結果表明:井底波動壓力隨著偏心度的增加而降低,完全偏心時可降低50%左右;波動壓力隨著造斜點深度、管柱運行深度、管柱運行速度和加速度等參數的增加而增加;下鉆時,井底波動壓力隨泵排量的增加而增加;起鉆時,井底抽汲壓力隨泵排量的增加而減小。在現場鉆井作業中應充分考慮這些因素對波動壓力的影響,最終將起下鉆速度限定在軟件計算出來的最大起下鉆速度之內。
[Abstract]:In the operations such as casing drilling in narrow annular gap, small hole drilling, deep water drilling and horizontal well drilling in long horizontal section, the accurate calculation model of fluctuation pressure is to accurately predict bottom hole pressure and avoid wellbore and well leakage.The premise of the occurrence of complex downhole conditions such as wellbore instability.The commonly used wave pressure prediction models, such as Burkhardt model and Schuh model, are established for concentric annulus, but in the horizontal and inclined sections of horizontal wells, they are affected by gravity factors and cuttings bed.It can cause the string to be eccentric in the annulus.The calculation methods of wave pressure in eccentric annulus and concentric annulus are different.Aiming at the above problems, a steady and transient wave pressure calculation model for horizontal wells is established in this paper.In this paper, the influence of eccentricity on wave pressure in horizontal section of horizontal well is analyzed, and an improved golden section algorithm for fitting rheological parameters of drilling fluid and optimal selection of rheological model is proposed.The velocity distribution of annular fluid in different drill string working conditions is analyzed, and the influence of drill pipe joint, static shear force of drilling fluid and string acceleration on fluctuating pressure is analyzed.Secondly, according to the steady state and transient flow state of fluid in horizontal well, the calculation models of fluctuating pressure are established, and different eccentricity, rheological mode of drilling fluid and working condition of pipe string are considered in the process of establishing the model.The rationality of the model is verified. The calculation results of steady wave pressure of the flow in concentric annulus and eccentric annulus respectively and the error of many groups of experimental data measured by predecessors are within 10%.The maximum error between the transient wave pressure model and two wells measured by Burkhardt and Clark is 11.5% and 9.93% respectively.Finally, according to the established calculation model of wave pressure in horizontal wells, the calculation software of wave pressure is compiled by using Matlab language, and the sensitivity of parameter of wave pressure calculation model is analyzed by example calculation.The results show that the downhole wave pressure decreases with the increase of eccentricity, and decreases by about 50% at complete eccentricity, and the fluctuating pressure increases with the increase of the depth of diagonal point, the operating depth of string, the running speed and acceleration of string, etc.During drilling, the bottom hole fluctuation pressure increases with the increase of pump displacement, while the bottom hole swabbing pressure decreases with the increase of pump displacement.The influence of these factors on the fluctuating pressure should be fully considered in the field drilling operation, and finally the down-drilling speed should be limited to the maximum down-drilling speed calculated by the software.
【學位授予單位】：西安石油大學
【學位級別】：碩士
【學位授予年份】：2017
【分類號】：TP311.52;TE21

【相似文獻】

相關期刊論文 前10條

1 周全興;;波動壓力的計算與討論[J];石油鉆采工藝;1988年04期

2 周開吉,楊金華,鐘兵,唐林;井內波動壓力[J];石油鉆采工藝;1990年02期

3 蔣祖軍;用動態法研究井內波動壓力[J];石油鉆采工藝;1991年03期

4 鐘兵,周開吉,郝俊芳,趙景民,張世同;井內瞬態波動壓力分析[J];西南石油學院學報;1989年02期

5 樊洪海,劉希圣;賓漢液體直井穩態波動壓力計算模式研究[J];石油鉆采工藝;1993年03期

6 周開吉，，鐘兵，袁其驥，柳萍;擬瞬態井內波動壓力預測模型[J];西南石油學院學報;1995年04期

7 王竹林;;鉆井泵瞬態波動壓力之間的比較[J];內江科技;2010年05期

8 鐘兵;周開吉;郝俊芳;李根民;趙景民;;井內波動壓力動態模擬及影響因素[J];天然氣工業;1990年05期

9 顧軍;;計算井內波動壓力的簡單方法[J];鉆采工藝;1992年04期

10 吳雪平,金業權;修正的穩態波動壓力計算法在狹窄環空下套管中的應用[J];重慶科技學院學報;2005年02期

相關碩士學位論文 前5條

1 王再興;水平井波動壓力計算理論建模及軟件開發[D];西安石油大學;2017年

2 孫旺;大斜度井下套管波動壓力計算分析[D];中國石油大學(華東);2015年

3 李啟明;適于水平井的波動壓力預測新模型研究[D];東北石油大學;2011年

4 呂華東;高溫高壓條件下的井低波動壓力預測模型研究[D];東北石油大學;2014年

5 黃哲;液化粉質土波動壓力垂向分布試驗研究[D];中國海洋大學;2014年

本文編號：1716725