【摘要】：采用機械力化學方法,在4-二甲氨基吡啶(DMAP)催化下一步法制備乙�；{米纖維素(A-NCC)。通過單因素研究方法,對影響A-NCC得率的DMAP用量、球磨時間、反應溫度、超聲時間、反應時間等因素進行探討及分析。采用透射電子顯微鏡(TEM)、X射線衍射儀(XRD)、熱分析儀(TGA)、傅里葉變換紅外光譜儀(FTIR)和X射線光子能譜分析(XPS)等對所制備A-NCC的形貌、熱穩定性和譜學性能進行分析表征,采用滴定法測量表面羥基的取代度。結果表明:機械力化學法制備的A-NCC呈細長狀,直徑約為10~30nm,長度約為200~750nm,結晶度為76%,取代度(DS)在0.125~0.214之間;TGA分析表明,A-NCC熱分解溫度為311℃,低于竹漿。采用機械力化學法制備乙酰化納米纖維素具有工藝簡便、綠色環保的優點。
[Abstract]:Acetylated nanocellulose (A-NCC) was prepared by mechanochemical method using 4-dimethylaminopyridine (DMAP) as catalyst. The factors influencing the yield of A-NCC, such as DMAP dosage, milling time, reaction temperature, ultrasonic time, reaction time and so on, were discussed and analyzed by single factor research method. The morphologies of A-NCC prepared by transmission electron microscope (TEM), (TEM), X ray diffractometer (XRD), (XRD), thermal analyzer (TGA), Fourier transform infrared spectroscopy (FTIR) and X-ray photon spectroscopy (XPS) were analyzed. The thermal stability and spectroscopic properties were characterized and the degree of substitution of surface hydroxyl groups was measured by titration. The results show that the A-NCC prepared by mechanochemical method is thin and long, with a diameter of 10 ~ 30 nm, a length of about 200 ~ 750 nm, a crystallinity of 76 and a degree of substitution of 0.125 ~ 0.214; TGA analysis showed that the thermal decomposition temperature of A-NCC was 311 鈩，

本文編號：2313216