本文選題：噴霧干燥 + 正交實驗�。� 參考：《含能材料》2016年05期

【摘要】：以丙酮為溶劑,采用L_9(3~4)正交實驗優化了噴霧干燥制備球形HMX的工藝條件。利用掃描電鏡(SEM)對優化條件下所得的球形HMX進行了表征。采用評分法定量分析了其形貌。結果表明,球形HMX的最優制備條件為:入口溫度70℃,進料速率1.5 mL·min~(-1),噴霧氣體流速473 L·h~(-1),質量分?jǐn)?shù)1.5%。最優制備工藝條件下所得HMX顆粒的中值粒徑為997.56 nm,晶型為β型。與HMX原料相比,球形HMX的撞擊感度的特性落高提高28.21 cm。
[Abstract]:Using acetone as solvent, the orthogonal experiment was carried out to optimize the process conditions for the preparation of spherical HMX by spray drying. The spherical HMX obtained under the optimized conditions was characterized by SEM. The morphologies were quantitatively analyzed by scoring method. The results show that the optimum preparation conditions of spherical HMX are as follows: inlet temperature 70 鈩，

本文編號：1796609